Toshiba Regza XV55 Series Manual page 43

Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below.
LED indication
Condition
LED-2 LED-1
OFF Green (Solid) The TV is operatin
OFF Red (Solid) Standby with Power-
Green Red (Solid) Active standby
(Solid) (Digital mode)
OFF Green (Solid) Sleep timer
(Analogue mode)
OFF RED Blinks Power protect
0.5 sec cycle
OFF Red Blinks Abnormal operation
1 sec cycle of BUS line.
OFF 2 times Abnormal operation
flashing with (Initialization error).
2 sec interval
Q
Why does the GREEN Active Standby LED
sometimes take longer to go out?
A
When put into standby the television's active standby
will automatically search all available channels for
downloads, provided Auto upgrade is On. The time
it takes to do this may vary.
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
Manual setting
Colour system: Auto.
EXT2
Store
OK
Back
MENU
a
Set the Colour to Auto. and exit.
b
Go to the Picture settings menu and adjust the tint.
Solution
–
properly.
–
On
–
–
detection.
Turn OFF the TV and
unplug the power
cord. Plug the power
cord in again and turn
ON the TV.
LED-2 LED-1
A V C R
Watch TV
EXIT
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 9).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption. Try Lip Sync setting to Off.
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed settings of the
device, turn off your television and unplug the power
cord, then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device and
lead again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK is disconnected the logo will
disappear after approximately one minute.
43
PROBLEM SOLVING