Connecting A Usb Device; Plugging In The Receiver - Onkyo TX-SR353 Operating Instructions Manual

2
2

Connecting a USB device

It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
...
Switch the receiver into standby then connect your
USB device to the USB terminal on the front panel of
this receiver.
• It is not possible to connect an iPod/iPhone or a similar
device to this receiver and play back music files.
• This receiver does not support a USB hub.
• For instructions on playing the USB device, see
USB device on page 20.
MASTER VOLUME
UNING PRESET
ENTER RETURN
USB
SETUP MIC USB
5V / 0.5A
TX- SR353
AV RECEIVER
USB mass
storage device

Plugging in the receiver

Only plug in after you have connected all your components
to this receiver, including the speakers.
...
Plug the AC power cord into a convenient AC power
outlet.
CAUTION
• Handle the power cord by the plug. Do not pull out the plug
by tugging the cord and never touch the power cord when
your hands are wet as this could cause a short circuit or
Playing a
electric shock. Do not place the unit, a piece of furniture,
etc., on the power cord, or pinch the cord. Never make a
knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped
on. A damaged power cord can cause a fire or give you an
electrical shock. Check the power cord once in a while.
When you find it damaged, ask your nearest Onkyo
authorized service center or your dealer for a replacement.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular use,
e.g., when on vacation.
This receiver
15
Connecting your equipment
2
4
31