Q Q - Pioneer XV-DV434 Service Manual

1
Using this unit with a Pioneer
QQ
plasma display
3 7 63 1515 0
If you have a Pioneer plasma display (models
PDP-504HDG and PDP-434HDG), you can use
A
an SR+ cable 1 to connect it to this unit and
take advantage of various convenient features,
such as automatic video input switching of the
plasma display when the input is changed.
Media receiver
CONTROL
OUT
B
OPTICAL IN
AUDIO
LINE 2
COMPONENT
VIDEO OUT
Y
VIDEO
OUT
C
SERVICE PARTS
•
TE
L 13942296513
D
E
www
F
106
1
http://www.xiaoyu163.com
2
Pioneer plasma display
XV-DV535
CONTROL
FM AM
ANTENNA
UNBAL 75 LOOP ANTENNA
P
B
P
R
S-VIDEO
OUT
VIDEO
SR+ mini-plug cable
(ADE7095)
x ao
y
. i
2
http://www.xiaoyu163.com
3
• Use a 3-ringed miniplug SR+ cable to
connect the CONTROL IN jack of this unit
8
through a media receiver to the CONTROL
OUT jack of your plasma display. 2
Before you can use the extra SR+ features, you
need to make a few settings in the unit. See
SR+ Setup for Pioneer plasma displays
detailed instructions.
Using the SR+ mode with a Pioneer
plasma display
When connected using an SR+ cable, a
number of features (such as automatic video
input switching and volume muting 3 on the
plasma display) become available to make
using this unit with your Pioneer plasma
display even easier.
See also SR+ Setup for Pioneer plasma displays
for information on setting up the
unit.
1 Make sure that the plasma display and
this unit are switched on and that they are
connected with an SR+ cable.
See Using this unit with a Pioneer plasma
display above for more on connecting these
components.
2 Press SR+ on the remote.
3 When you see 'Setup?' appear in the
display, use | / \ to select ' SR+ On' or ' SR+
Off' .
• If SR+ Error shows in the display, it means
there is a communication problem

Q Q

between the unit and the plasma display.
3 6 7 1 3
Check all connections and retry.
Note
• The 3-ringed SR+ cable from Pioneer is
commercially available under the part
number ADE7095. Contact the Pioneer
Customer Support division for more
information on obtaining an SR+ cable.
• You wonít be able to use the remote sensor
of this unit with the CONTROL IN jack of
this unit connected to the CONTROL OUT
jack of your plasma display. You can use
the remote sensor of the plasma display
(even in standby) as long as the power isnít
switched off.
• The automatic volume muting feature is
enabled separately; see SR+ Setup
for Pioneer plasma displays
• If you disconnect the SR+ cable or switch
the plasma display off while SR+ is on, the
setting automatically reverts to SR+ OFF.
This displays an error if you switch the
input of the unit with the plasma display
switched off. Likewise, if this unit is sw
off, the link with the plasma display will
be terminated.
u163
.
XV-DV333
3
4
2 9 9 4 2 8
4
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9