Advertisement
To avoid personal injury, do not modify or weld hydraulic equipment .
All EAGLE PRO torque wrenches are designed for a maximum of 10,000 PSI/700 bar. Do not connect
torque wrenches to a pump with a higher pressure rating or equipment damage may occur.
Use high quality impact sockets that are in good condition with the hydraulic torque wrench. Ensure they
are the correct size and engage the hex portion of the bolt/nut correctly. Unseen flaws or damage to the
impact sockets could cause failures during use. Remain clear of impact sockets during application.
Do not hammer on hydraulic torque wrench, pump or socket to enhance performance. If the bolt/nut will
not rotate, select a larger torque wrench for the application.
Do not pick up the torque wrench by the hydraulic hose or swivel.
Do not pick up the hydraulic pump by the power cord, pendant control cord, or hydraulic hose.
Electrical pumps should never be used in a potentially explosive environment.
Ensure that the pump is properly grounded to guard against electrical shock.
Do not use kinked or damaged hydraulic hoses.
Carefully inspect the hydraulic couplers on pump, hoses, and torque wrenches before using. Never
connect tools with damaged couplers or damaged port threads. The damaged coupler(s) or damaged port
threads may cause equipment failure and possible personal injury.
Install couplers in a clean environment. Always prevent dirt or other debris from entering into the
cylinder. Dirt or debris will damage the tool and result in equipment failure and possible personal injury.
Before removing or tightening hose(s) or coupler(s), always release hydraulic pressure in system .
Never handle pressurized hoses; escaping oil under high pressure can penetrate the skin, causing serious
injury. Seek medical aid immediately if injured.
When the pump is not in use, release the valve, remove the hoses and use the dust cap to recover the port.
Do not drop anything on hydraulic hoses.
Fully retract the hydraulic torque wrench before adding fluid to the torque wrench pump. Failure to do so
will result in excess reservoir pressure and could cause personal injury.
Do not use equipment in temperatures of 150°F (65°C) or higher. Overheating will soften seals and
weakens hose materials, resulting in oil leaks or other equipment failure.
Use only EAGLE PRO brand replacement parts
NEVER attempt to tighten more than the capacity of the torque wrench. Overloading will cause equip-
ment failure and personal injury.
Maximum operating pressure is 10,000 psi,(700 bar). NEVER use a pump or relief valve with a higher
pressure rating to operate the torque wrench. Pressure above 10,000 psi could cause equipment failure
and possible personal injury.
Do not place any part of the body between the reaction arm and the reaction point.
Do not place any objects between the reaction arm and the reaction points. Ensure all hoses are kept
away from the reaction points.
EAGLE PRO INDUSTRIAL TOOLS, INC.
3
FORM NO. E10002 REV. A.
Advertisement
