Messages On The Screen - Panasonic DMP-UB900 Operating Instructions Manual

When using wireless LAN connection, video
from the DLNA Certified media server is not
played back or video frames are dropped
during playback.
Higher transfer rate router such as 802.11n
(2.4 GHz or 5 GHz) wireless router may solve
the problem. If you use 802.11n (2.4 GHz or
5 GHz) wireless router, it is necessary to set
the encryption type to "AES".
Simultaneous use with a microwave, cordless
telephone etc. at 2.4 GHz may result in
connection interruptions or other problems.
On the "Wireless Settings" screen (
continuous lighting of at least 4 "Reception"
indicators is the target for a stable connection.
If 3 or fewer indicators are lit or the
connection is being interrupted, change the
position or angle of your wireless router and
see if the connection state improves. If there
is no improvement, connect to a wired
network and perform the "Easy Network
Setting" ( 17) again.

Messages on the screen

Cannot read. Please check the disc.
You inserted an incompatible disc.
Cannot play this title.
You tried to play a non-compatible image.
No disc inserted.
The disc may be upside down.
$ This operation cannot be performed now.
Some operations are unsupported by the unit.
(For example, reverse slow motion, etc.)
IP address is not set.
The "IP Address" in "IP Address / DNS
Settings" is "---. ---. ---. ---". Set the "IP
Address", "Subnet Mask", and "Gateway
Address". (Select the automatic address
acquisition if necessary.)
The wireless access point currently has a low
network security setting. It is recommended to
change to a higher setting.
Set a stronger network security level referring
to the wireless router operating instructions.
Messages on the unit's
display
F99
The unit fails to operate properly. Touch [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
NET
While connecting to a network.
NO PLAY
There is a viewing restriction on a BD-Video
32), the
or DVD-Video. (
NO READ
The media is dirty or badly scratched. The
unit cannot play.
REMOVE
The USB device is drawing too much power.
Remove the USB device.
SET CODE
(" " stands for a number.)
The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold
[OK] and the
indicated number
button at the same time for more than
5 seconds.
U59
Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
START
A firmware update will start. Please do not
turn off the unit.
UPDATE /5
(" " stands for a number.)
A firmware update is in progress.
Please do not turn off the unit.
FINISH
The firmware update is complete.
33)
SQT1293
39