Separate Purchase - LG 43UH61 Series Owner's Manual

Antenna Isolator Installation Guide (Depending on model)
- Use this to install TV in a place where there is a voltage
di erence between TV Set and GND of antenna signal.
» If there is a voltage difference between TV Set and GND of
antenna signal, the antenna contact might be heated and
excessive heat might cause an accident.
- You can improve the safety when watching TV by e ciently
removing power voltage from TV antenna. It is recommended
to mount the isolator to the wall. If it cannot be mounted to
the wall, mount it on the TV. Avoid disconnecting the antenna
Isolator after installation.
- Before starting, be sure that the TV antenna is connected.
1. Connect to TV.
Wall
ANTENNA/
CABLE IN or
Cable /
Isolator
Antenna
2. Connect to Set-Top box.
Connect one end of the isolator to cable/antenna jack and the other to
TV set or set-top box.
"Equipment connected to the protective earthing of the building
installation through the mains connection or through other equipment
with a connection to protective earthing - and to a cable distribution
system using coaxial cable, may in some circumstances create a re
hazard. Connection to a cable distribution system has therefore to be
provided through a device providing electrical isolation below a certain
frequency range (galvanic isolator, see EN 60728-11)"
When applying the RF Isolator, a slight loss of signal sensitivity can
occur.
CAUTION
Do not use any unapproved items to ensure the safety and product
life span.
Any damage or injuries caused by using unapproved items are not
covered by the warranty.
Some models have a thin lm attached on to the screen and this
must not be removed.
When attaching the stand to the TV set, place the screen facing
down on a cushioned table or at surface to protect the screen
from scratches.
Make sure that the screws are inserted correctly and fastened
securely. (If they are not fastened securely enough, the TV may tilt
forward after being installed.) Do not use too much force and over
tighten the screws; otherwise screw may be damaged and not
tighten correctly.
Make sure to wring any excess water or cleaner from the cloth.
Do not spray water or cleaner directly onto the TV screen.
Make sure to spray just enough of water or cleaner onto a dry cloth
to wipe the screen.
When cleaning the product, be careful not to allow any liquid or
foreign objects to enter the gap between the upper, left or right
side of the panel and the guide panel. (Depending on model)

Separate purchase

Separate purchase items can be changed or modi ed for quality
improvement without any noti cation. Contact your dealer to buy these
items. These devices only work with certain models.
The model name or design may be changed depending on the upgrade
of product functions, manufacturer's circumstances or policies.
(Depending on model)
AG-F*** AN-MR650
Cinema 3D Glasses Magic Remote
AN-VC550 AG-F***DP
Smart camera Dual Play Glasses
9