Philips BDL4221V/00 Service Manual page 106

106
420WN6 LCD TV
Go to cover page
4.0 Visual characteristics
4.1 Test conditions
Unless otherwise specified, this specification is defined under the following conditions.
(1) Input signal
(2) Luminance setting: controls to be set to 500 cd/m
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light:
(5) Ambient temperature: 25 +/-2 °C
4.2 PC Resolution
Dot rate (MHz)
25.175
25.175
31.500
28.322
36.000
40.000
49.500
65.000
78.750
74.500
79.500
84.75
4.3 Brightness
>400 cd/m
4.4 Image size
42"BDS WXGA TFT LCD Monitor/TV
TYPE
BRAND : PHILIPS
2005-06-10
Freud Yu
GENERAL PRODUCT SPECIFICATION
: As defined in 3.3.1.5, 1360 x 768 x 60Hz
non-interlaced mode (47.720kHz), signal
sources must have 75 ohm output impedance.
full screen 700mv white signal.
400 ~ 600 lux.
H.freq (KHz) Mode
31.469 VGA-1
31.469 IBM VGA
37.500 VGA
31.469 VGA
35.156 VESA
37.879 VESA
46.875 VESA
48.363 VESA
60.023 VESA
47.772 WXGA
47.776 WXGA
47.720 WXGA
2
at maximum contrast and Brightness. (At center of the screen, Fig. 1)
: 420WN6VB/00
2005-06-10
2
(typical) with
Resolution
640*350
640 * 480
640 * 480
720*400
800 * 600
800 * 600
800 * 600
1024 * 768
1024 * 768
1280 * 720
1280 * 768
1360 * 768
8639 000 16494
590 28
45
V.freq (Hz) Remark
70.086
59.940
75.000
70.087
56.250
60.317
75.000
60.004
75.029
59.855 CVT
59.870 CVT
59.799 CVT