Specifications; Ec Declaration Of Conformity - Makita DP4010 Instruction Manual

ENGLISH (Original instructions)
1-1. Lock button
1-2. Speed control screw
1-3. Switch trigger
1-4. Higher
1-5. Lower
2-1. Reversing switch lever

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Vibration
The vibration total
determined according to EN60745:
Work mode: Drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
3-1. Arrow
3-2. Speed change knob
4-1. Grip base
4-2. Side grip (auxiliary handle)
4-3. Teeth
4-4. Protrusions
Model
Speed
Steel
Wood
-1
)
Overall length
Net weight
Safety class
) : 80 dB(A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h,D
2
8 mm
25 mm
0 - 2,900
ENE032-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENF002-1
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG104-1

EC Declaration of Conformity

We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
2-speed drill
ENG202-3
Model No./ Type: DP4010,DP4011
are of series production and
sum)
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
ENG901-1
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
5-1. Chuck key
6-1. Sleeve
6-2. Ring
7-1. Depth gauge
8-1. Vent holes
DP4010/DP4011
High
347 mm
2.3 kg
/II
Corporation as
Low
13 mm
40 mm
0 - 1,200
ENH101-12
the responsible