Samsung AM0 SERIES Installation Manual page 40

Option SEG19
Explanation PAGE
Remote
Controller
Display
Indication Details Indication
Indication and
Details
3
* Advanced function: Controlling cooling/heating current or power saving with motion detect.
Minimizing fan operation when thermostat is off
(*1)
- Fan operates for 20 seconds at an interval of 5 minutes in heat mode.
- Fan stops when thermostat is off in cooling mode
- Make sure to connect the wired remote controller or the external room temperature sensor if you use the
function of external room temperature sensor or minimizing fan operation (in order to implement the functions
the option of using temperature sensor inside the wired remote controller must be set. Refer to the install manual
of the wired remote controller.
1: Fan is turned on continually when the heater is turned on
(*2)
Default setting value
(*3)
- 2 °C (3.6 °F)
• Do not install the electronic heater in the external supply duct connected to the AHU.
CAUTION
Electronic heater should
not be installed.
AM0**JNZDCH/AA IM ENG_V1.5_07082015
SEG20 SEG21
Heating setting compensation
Details
Heating Setting
Details Indication
Compensation
0 Default (*3)
1 2 °C (3.6 °F)
2 5 °C (9 °F)
Discharge side Suction side
Air Flow
Indoor unit
SEG22
EEV Step of stopped
unit during oil return/
defrost mode
Indication Details Indication
Default
0
value
Oil return
or Noise
1 decreasing
in defrost
mode
39
SEG23 SEG24
- -
Details