Advertisement
CONNECTION AND OPERATION
LOUDSPEAKER CONNECTIONS
The speaker terminals are spring loaded. To connect, press the terminal down to
open it. Insert the bare end of the cable into the hole in the socket. Release the
terminal. Make sure the terminal traps the bare wire and not the insulation.
!
Connect the loudspeakers as shown n the diagrams The cable has a stripe
on one core. Connect this to the Positive (RED) terminal. Connect the plain
core to the Negative (BLACK) Terminal.
RIGHT SPEAKER LEFT SPEAKER
Insert
Press
Release
RIGHT
LEFT
FINAL CONNECTIONS
!
Extend the FM antenna. Do NOT cut it short!
!
When running speaker cables, keep them well away from areas whey they
could cause a danger to people or pets.
!
Connect the power cord to the mains point but do not switch on.
SWITCHING ON
!
Plug in the mains plug and switch the system on at the mains point.
!
The system will respond and go into Standby. The RED standby light will glow
on the front panel.
!
Press the
POWER/STANDBY
button
on the unit.
The unit switches on and
the display lights up. In normal use the system will revert to the mode and
volume as last used.
PLAYING A CD
!
Set the
CD/RADIO
switch to
CD
!
Press the
DOOR OPEN
button
.
!
Place a CD (label side up)on the central spindle lock
!
Press gently to secure the CD in place.
!
Close the CD door.
!
The disc will spin briefly, then stop. The display will
indicate the number of tracks on the disc .
TO PLAY A CD FROM THE START
!
Press the PLAY/PAUSE button
!
The disc will play from Track 1
TO PAUSE A CD WHILE PLAYING
!
Press the
PLAY/PAUSE
button
!
The disc will pause. In Pause mode the sound mutes
and the display flashes.
TO STOP A CD WHILE PLAYING
!
Press the STOP button
TO PLAY A CD FROM A SELECTED TRACK
!
Insert the CD
!
Press SKIP
or
to select the track.
!
Press PLAY/PAUSE
to play from the track.
TO CHANGE TRACKS DURING PLAY
!
Press SKIP
or
repeatedly, to select and
then play from the desired track.
TO RETURN TO THE START OF A TRACK DURING PLAY
!
Press SKIP
once.
RAPID SEARCH FOR A PASSAGE DURING PLAY
Press and hold SKIP
or
until the passage is
located. Release the button to return to normal play.
During rapid search the volume is reduced
6
PRELIMINARIES
SITING AND PLACEMENT
UNPACKING
Check that the mains voltage on the rating plate
which is located at the rear of the unit matches the
T
he carton contains:
mains voltage in your area.
!
The MC 307 AM/FM/CD receiver:
!
Unwrap the power cord
!
One pair of loudspeakers:
!
Uncoil the FM antenna and extend it fully.
!
Remote handset and batteries
Make sure there is a suitable power point within
Unpack and inspect the components carefully. If
easy reach.
any item is damaged or missing, contact the Tesco
store from where you purchased this product, or if
The means of disconnection of the appliance is the
that is not possible, your nearest Tesco store. Please
mains plug. This must not be obstructed and must
have your receipt ready when you call.
be freely operable at all times.
Retain the packaging. If you dispose of it, do so in
Site the system on a stable surface (ideally a stout
accordance with recycling regulations in your area.
shelf) where it is unlikely to fall or get knocked over.
This is specially important in the case of the
Retain the User Handbook. If you pass the unit on to
speakers which should be placed on either side of
a third party make sure you pass on the handbook.
the main unit with at least150mm between each
PREPARATION
speaker and the main unit.
CD COMPARTMENT
The radio performance of the system is dependent
Remove the two strips of tape over the CD door.
on the aerial.
Press the DOOR OPEN button to open the CD lid.
The FM aerial should be moved around to get the
Carefully remove the protective card from the CD
optimum results.
mechanism.
antenna lead.
Close the CD door and discard the card and the
The AM aerial is internal to the system, so if you
pieces of tape.
need good medium wave reception, try the system
in different locations before making a final choice.
Make sure that you position the unit where the
remote handset can easily be operated in direct line
of sight and no more than 3 metres away.
CD TOPICS
Dirty, scratched or warped discs may cause
skipping or noise.
Handle the disc only by the edges. To keep discs
clean, do not touch the surface.
Discs should be stored in their cases after use to
avoid scratches.
Do not expose discs to direct sunlight, high humidity,
high temperature, dust, etc. Prolonged exposure to
extreme temperatures can warp the disc.
Do not stick or write anything on the disc. Sharp
writing instruments or the inks used in some felt tip
pens may damage its surface.
When loading a CD into the player:
Position the disc over the centre spindle
Make sure the printed side faces out
Press the CD gently into place
NEVER use force
Do not extend or cut the FM
When removing a CD from the player:
Press lightly on the centre spindle
Gently ease the CD off by holding it at the edges.
Do not touch the playing surface
NEVER use force
3
Advertisement
