Lens Replacement - Strong STR 650-1000 F+PF User Manual

When you remove the lamp replace with a new one of the same
characteristics (Gx9.5 lamp holder).
Then, reinsert, first the pins, the lamp into the socket by pushing.
Make sure the lamp is properly held. Finally, close the projector front
access and the front access fastener (see 7 in figure 2).
Connect the spotlight and check that the lamp is functioning properly.

5.3. Lens replacement

Before proceeding to change the lens, make sure that the projector has not
been running recently because it could be hot; if so let it cool for a few
minutes.
To change the lens, open the front access fastener (see 7 in figure 2). The
lens installed is at your right. An iron ring is placed around the lens. Remove it
with the help of a tool to pry it open.
WARNING: The ring holds the lens, be careful not to fall it down.
Tilt the projector and remove the lens, you can press it by the outside to
help it out. Insert the new lens. To improve the quality of the light beam be
sure of its cleanness.
Finally reinsert the steel ring for holding the lens correctly. Close the front
part of the projector and fasten it (see 7 in figure 2).
Verify that the light beam of the new lens is correct.
User manual STR 650-1000 F+PF 12