How To Check Lamp Used Time; Warning Message On The Non-Standard Lamp Used - Sanyo PLC-XU4000 Service Manual
Hide thumbs
Also See for PLC-XU4000:
- Owner's manual (78 pages) ,
- Brochure & specs (2 pages) ,
- Specification sheet (1 page)
Table of Contents
Advertisement
Lamp Replacement
How to check Lamp Used Time
The LAMP REPLACE indicator will light yellow
when the total lamp used time (Corresponding
value) reaches 5,000 hours. This is to indicate
that lamp replacement is required.
You can check the lamp used time following
to the below procedure.
1
Press and hold the oN/StANd-BY
button on the projector or the remote control
for more than 20 seconds.
2
The projector used time and lamp used
time will be displayed on the screen briefly
as follows.
Warning Message on the non-standard lamp used
If the non-standard lamp is used, the warning and confirmation messages will appear on the screen every startup.
Some of the functions are limited when the non-standard lamp is used in spite of the warning.
Counter
Projector
Lamp
Auto
Normal
Eco1
Eco2
Corresponding value
Since the lamp is not standard,
projector failed to read lamp data.
Continue to use this lamp?
Yes
No
-10-
Projector used time
650H
200H
150H
250H
250H
750H
Total lamp used time
Cumulative
lamp
operating
time in each
mode.
Advertisement
Table of Contents
