Checking Wiring And Connectors - Yamaha F30A Owner's Manual

Then tighten 1/4 to 1/2 turn more. Tighten
the drain screw to the correct torque with a
torque wrench as soon as possible.
4. Add the correct amount of oil through the
filler hole. Install the filler cap. NOTICE:
Overfilling the oil could cause leak-
age or damage. If the oil level is
above the upper level mark, drain un-
til the level meets the specified ca-
pacity.
[ECM01850]
Recommended engine oil:
4-stroke outboard motor oil
Engine oil quantity (excluding oil filter):
2.0 L (2.11 US qt, 1.76 Imp.qt)
1
1. Oil filler cap
5. Start the engine and watch to make sure
the low oil pressure-alert indicator (if
equipped) turns off. Make sure that
there are no oil leaks. NOTICE: If the
low oil pressure-alert indicator does
not turn off or if there are oil leaks,
stop the engine and find the cause.
Continued operation with a problem
could cause severe engine damage.
Consult your Yamaha dealer if the
problem cannot be located and cor-
rected.
[ECM00682]
6. Turn off the engine and wait 3 minutes.
Recheck the oil level using the dipstick
to be sure the level falls between the up-
per and lower marks. Fill with oil if it is
below the lower mark, or drain to the
specified level if it is above the upper
mark.
7. Dispose of used oil according to local
regulations.
TIP:
For more information on the disposal of
●
used oil, consult your Yamaha dealer.
Change the oil more often when operating
●
the engine under adverse conditions such
as extended trolling.
ZMU04086
EMU29112

Checking wiring and connectors

Check that each grounding wire is properly
●
secured.
Check that each connector is engaged se-
●
curely.
Maintenance
ZMU02058
ZMU04087
67