Pentek 7858 Getting Started Manual page 11

Pentek Model 7858 Getting S t a r t e d G u i d e
ReadyFlow Software (continued)
Windows / VxWorks − The installation steps can be summarized as follows:
• Installing ReadyFlow for VxWorks in a Windows system
• Importing the ReadyFlow projects into Wind River Workbench
• Building ReadyFlow projects in Wind River Workbench
• Building the ReadyFlow library
• Building the ReadyFlow example programs
For complete details, refer to Chapter 2 of the Model 4996A Option 156 User's Guide
(813.71560).
GateFlow FPGA Design Kit
The following software and hardware is required to use the GateFlow FPGA Design
Kit:
• Xilinx's Foundation ISE (Version 11.4 or later − the design kit was produced using
ISE Project Navigator Release 11.4).
• Xilinx's Platform Cable: To connect to your development computer system you will
need one of the following two cables, purchased from Xilinx:
The Parallel Cable IV has two connectors at one end that both connect to your com−
puter system, one to the ECP−enabled Parallel port (you may need to check this
port setting in your BIOS) and the other, a 5V supply connection, may be inserted
between your mouse or keyboard and its PS/2 port, or simply plugged into one of
those ports if your mouse and keyboard connect via USB.

The Platform USB cable connects to a USB port on your development computer
system, and thus carries its own 5V supply connection. 

The other end of both cables terminates in a pod, which contains a shrouded con−
nector for a 14−pin, 2 mm pitch ribbon cable. The ribbon cable is included with the
shipment of both Xilinx programming cables.
To install the FPGA Design Kit for the Model 7158 module's Processing FPGA, copy the
\GateFlow folder on the DVD−ROM to the root directory of the C: drive of the system
you'll be working on.
• Parallel Cable IV (Model DLC7, Xilinx part # HW−PC4)
• Platform Cable USB (Model DLC9, Xilinx part # HWUSB−G)
Pa ge 1 1
Rev. C