External Inspection & Cleaning Of The Flame Trap; Cleaning The Combustion Chamber And Flame Trap - Kenmore 153.552400 Use And Care Manual

6. Using the old pilot tube as a guide, bend the new pilot tube
to match the old one. Make only the bends closest to the
pilot before going to the next step.
NOTE: Skip this step if you are reusing the existing
pilot tube.
7. Reconnect the pilot tube and tighten the nut securing it to
the new pilot assembly. To prevent any bending of the pilot
bracket, use pliers to hold the pilot assembly bracket while
tightening the pilot nut. IMPORTANT: Keep the pilot orifice in
the pilot when making the connection. DO NOT operate the
water heater without the pilot orifice installed.
THERMOPILE
CONNECTORS
PILOT TUBE
(FERRULE NUT
NOT SHOWN)
FIGURE 28.
8. Push the new pilot assembly connectors through the opening
in the burner door (See Figure 27).
9. Attach the pilot assembly to the Burner Door Assembly.
10. Position the new thermopile wires through the top opening of
the manifold component block (Figure 27). Be sure that the
igniter wire is positioned through the middle opening of the
manifold component block. Position the pilot tube through the
bottom opening of the manifold component block.
11. See "Replacing the Burner Door Assembly."
IGNITER CONNECTOR
PILOT THERMOPILE
PILOT/THERMOPILE
ASSEMBLY
External Inspection & Cleaning of the
Flame Trap
Although not likely to occur, if debris collects on the flame trap
(flame arrestor), use a vacuum, compressed air, or a soft bristle
brush to remove it. NOTE: If unable to inspect or clean the flame
trap from underneath, follow the "Cleaning the Combustion
Chamber and Flame Trap" section instructions.
FLASHLIGHT
MIRROR
Cleaning the Combustion Chamber and
Flame Trap
1. Follow the procedure outlined in "Removing the Burner
Door Assembly" section.
2. Use a vacuum cleaner/shop vac to remove all loose debris
in the combustion chamber (Figure 30). Use compressed
air to clear any dust or debris that may have accumulated
in the flame trap (flame arrestor).
3. Reassemble following the procedure under the "Replacing
the Burner Door Assembly" section.
25
FIGURE 29