Functions/Transport - Ernex Norsaw 805 User Manual

4. FUNCTIONS/TRANSPORT

4.1 On/Off switch
A green ON button and a red OFF button are located on the saw's front panel (Fig. 6). The ON button
is equipped with a lockable cover. The saw is provided with a low-voltage cutout as well as overload
protection which disconnects the power supply under overload conditions to prevent motor damage.
If this occurs, let the motor cool down for a few minutes, after which it will be ready to run again. Try
to avoid overloading motor.
4.2 Raising and lowering saw blade
Free the elevation arm by loosening the elevation locking clamp (Fig. 7), whereupon the blade may
now be raised and lowered. The saw blade may be locked into position at any height by retigh-
tening the locking clamp.
4.3 Tilting the saw blade
The saw blade must be in low position before adjusting bevel angle. This adjustment is made by
loosening the tilt locking clamp and pressing the tilt preset. The saw blade may now be tilted to any
bevel angle between 0° and 45° (Fig. 8), with the angle indicated on the curved scale. Tighten the
tilt locking clamp when finished.
4.4 Turning turntable
The turntable may be rotated horizontally in either direction and set at any cutoff angle. Loosen the
turntable by pushing locking handle to the left (Fig. 9). Turn the turntable to the desired cutoff angle
by means of the elevation arm (scale on table top indicates cutoff angle). Lock the turntable by push-
ing the locking handle to the right. Frequently used angles (90°, 45°, 30°, 22,5°, 15° and 0°) are
preset.
IMPORTANT! To prevent personal injury or damage to saw, the motor must be shut off while
making any saw blade adjustments.
When lifting using a crane, attachment straps can be placed around the legs. Wheels can be
supplied as an option.
9