Power Connection; Calendar And Time Setting - Jensen JCR-232 User Manual

Am/fm dual alarm clock radio with digital retro flip display

Hide thumbs

Table Of Contents

Table of Contents

AC POWER CONNECTION

This product operates on 120V~ 60Hz AC power supply. Plug the AC power cord into a household outlet AC source.

INSTALLING/REPLACING THE BACK-UP BATTERY

This unit is equipped with a battery back-up system, requiring one 3V

the time/calendar settings and radio presets during AC power outage. Prior to first use, please remove the plastic

battery insulator tab to activate the backup battery.

Unscrew and remove the BATTERY COMPARTMENT COVER.

Install one fresh CR2032 lithium battery into the battery compartment following the polarity diagram on the

BATTERY COMPARTMENT COVER. Use only the specified size and type of battery.

Replace the BATTERY COMPARTMENT COVER and tighten its screw.

Note: The unit will operate without a battery installed but your time & alarm setting and radio presets will be lost and

will have to be reset in the event of power interruption or failure.

IMPORTANT:

Be sure that the battery is installed correctly. Wrong polarity may damage the unit and void the warranty. For best

performance and longer operating time, we recommend the use of good quality alkaline battery.

This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it

can cause severe internal burns in just 2 hours and can lead to death.

Keep new and used batteries away from children. If the battery compartment does not close

securely, stop using the product and keep it away from children.

If you think batteries might have been swallowed or placed inside any part of the body, seek

BATTERY CARE:



Use only the size and type of battery specified.



If the unit is not to be used for an extended period of time, remove the battery. Old or leaking battery can cause

damage to the unit and may void the warranty.



Do not try to recharge battery not intended to be recharged; they can overheat and rupture (Follow battery

manufacturer's directions).



Do not dispose of battery in fire, battery may leak or explode.

POWER ON/STANDBY

In standby mode, tap the POWER ON/STANDBY

Press and hold

SETTING THE CALENDAR AND TIME

In standby mode, press and hold the SET MEM button for about 2 seconds to enter the calendar/time set mode.

The year indicator will flash on the LCD DISPLAY for up to 30 seconds prompting for a new entry.

While the display is flashing, repeatedly tap the  or  button to adjust to the correct year. Press and hold the

or  button for faster scanning backward or forward. Tap the SET MEM button to confirm.

Repeat steps #2 to #3 to adjust the month, day, time format, current hour and finally current minute in the same

way.

Notes:



The display sequence in calendar/time set mode will be as follows:

Year → Month → Date → 12/24 Hour Time Format → Real Time Hour → Real Time Min → Normal Time



To check the year while current time is displayed, tap the CALENDAR button once. The LCD DISPLAY will

change to year display for 5 seconds and then revert to current time automatically.



To check the date while current time is displayed, tap the CALENDAR button twice. The LCD DISPLAY will

change to date display for 5 seconds and then revert to current time automatically.



During the time set, if no button is being pressed within 10 seconds, the current display time will be automatically

stored.