How To Connect Writer When Upgrading Main/Sub Micon; Upgrading Of Each Microprocessor Software; Sub Microprocessor Software Version Upgrade - Sharp LC-19D1E/S-BK/WH Service Manual

2.2. How to connect Writer when upgrading MAIN/SUB MICON.

1. How to connect a tool for MAIN MICON
Remove a cover above the EXT5 of the TV's rear cabinet and connect 20P connector of I/O tool.
1
Connect a 20P connector of RC32C ROM writer to a I/O tool.
2
Connect the enclosed USB cable to the USB I/F terminal of RC32C Writer.
3
Connect the enclosed USB cable to the USB terminal of your PC.
4
20P
TV
2. How to connect a tool for SUB MICON
Remove a cover above the EXT5 of the TV's rear cabinet and connect 20P connector of I/O tool.
1
Connect a 20P connector of E8 Emulator Debugger to a I/O tool.
2
Connect the enclosed USB cable to the USB I/F terminal of E8 Emulator Debugger.
3
Connect the enclosed USB cable to the USB terminal of your PC.
4
TV

3. Upgrading of each microprocessor software

3.1. Sub microprocessor software version upgrade

1. Install "E8 Emulator Debugger" in CD-ROM.
2. access http://www.renesas.com/fmwk.jsp?cnt=/download_search_results.jsp&fp=/support/downloads/download_results&layerId=1612 to down-
load following two update packages:
1) E8 Emulator Software V.2.09 Release 02 for M16C, H8 Upgrade (Debugger package version)
Issue date: 2007-2-22 48.3M
2) High-performance Embedded Workshop V.4.02.00 Upgrade
Issue date:2006-12-10 52.5M
Install these packages.
3. connect E8 Emulator Debugger to PC from USB port. (drivers at folder "E8 Emulator Debugger")
4. connect E8 writer to LCD's 20PIN port which near EXT5 terminal, use convertor1.
5. run "High Performance Embedded Workshop" in start menu.
RC32C ROM Writer (M3A-2925G01)
Parts Code
QCNW-G882WJQZ
I/O tool
20P
Parts Code
KSETNA001WJZZ
E8 Emurator Debugger
Parts Code
QCNW-G882WJQZ
I/O tool
20P
3 – 2
Parts Code
KSETNA002WJZZ
LC-19D1E/S-BK/WH
Personal computer
USB
USB Cable
TERMINAL
Personal computer
USB
USB Cable
TERMINAL