Nikon F6 Instruction Manual page 185

Power source
Power switch
Exposure meter
Battery power
confirmation
Usable number of The usable number of film roll is tested under following conditions by
36-exposure film
rolls per set of
fresh batteries
Battery holder MS-41 provided (two 3V lithium batteries);
optional Multi Power Battery Pack MB-40 and AA-type battery
holder MS-40 available (for eight alkaline-manganese, lithium
or Ni-MH batteries, or one Rechargeable Li-ion Battery EN-EL4
with optional Battery Chamber Cover BL-3); built-in backup
battery for internal clock
Power ON, OFF and LCD panel illuminator on position
Auto meter shut-off 8 sec. after power turned on if no
operations are performed; activated by lightly pressing shutter
release button or pressing AF start button after power is
turned on
for sufficient power;
exhaustion; indicates low battery power; blinking
indicates batteries are j exhausted; no indication/symbol
appears when batteries are completely exhausted or
improperly installed
Nikon
Test 1
Camera setting: Using an AF-S VR 24-120mm f/3.5-5.6G ED lens,
Vibration Reduction function on, in Continuous Servo AF with film
advance mode at S and shutter speed of 1/250 sec.
Autofocus operation: After lightly pressing the shutter release button for
8 sec., autofocus operation covers the full range from infinity ( ) to the
closest distance and back to infinity ( ) before each shot. After the
exposure meter automatically turns off, the same operation follows for
the next shot.
Battery
3V lithium
AA-type alkaline-manganese
(with MB-40)
AA-type Ni-MH (with MB-40)
AA-type lithium (with MB-40)
Rechargeable Li-ion Battery EN-EL4
(with MB-40)
indicates batteries has began
Temperature
At 20°C/68°F
Approx. 15
Approx. 10
Approx. 30
Approx. 45
Approx. 35
At –10°C/14°F
Approx. 6
Approx. 1
Approx. 30
Approx. 35
Approx. 25
185