Optimizing narrow band reception with the rfx-250 and msc system remotes (20 pages)
Summary of Contents for Universal Remote Contorl UR2 211
Page 1
Operating Manual For Easy Clicker Universal Remote Control, Inc. www.universalremote.com OCE›0082E Rev 02 (02/14/12)
Page 2
Introduction This remote control is designed to operate most Digital, Analog Cable boxes, IPTV set top boxes and TVs. Button Functions...
Page 3
Replacing Batteries Before you program or operate the remote control, you must install two new AA alkaline batteries. STEP1 Remove the battery compartment cover from the back of your remote control. STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below.
Page 4
STEP2 Point the remote at the component and press and hold the [DEVICE] key for 3 seconds until the Device LED blinks off and turns back on. Continue holding the [DEVICE] key and press the numberkeys, one at a time, starting with 1, then2, 3...0.
Page 5
this for other Device until you have stored all the desired power commands into the [ALL OFF] button. STEP4 Press the [CH5] button to save the power commands you stored. The [STB] button will blink twice to confirm the Device have been saved. Programming for On Demand Button Programming for On Demand...
Page 6
Memory Lock System. Memory Lock System. This remote control is designed to retain programmed memory for 10 years — even after batteries are removed from the remote control. For additional information about your remote control, go to www.universalremote.com...
Need help?
Do you have a question about the UR2 211 and is the answer not in the manual?
Questions and answers