Panasonic DMC-FZ8P Service Manual page 34

Service Manual
Diagrams and Replacement
Parts List
Digital Camera
Model No.
DMC-FZ8P DMC-FZ8EGM
DMC-FZ8PC DMC-FZ8GC
DMC-FZ8PL DMC-FZ8GD
DMC-FZ8EB DMC-FZ8GK
DMC-FZ8EE DMC-FZ8GN
DMC-FZ8EF DMC-FZ8GT
DMC-FZ8EG DMC-FZ8SG
Vol. 1
Colour
(S)...........Silver Type (except PL/GD/GT)
(K)...........Black Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Block Diagram .......................................................................... S-2
S2.1. Overall Block Diagram .......................................................... S-2
S3. Schematic Diagram .................................................................. S-3
S3.1. Interconnection Diagram ....................................................... S-3
S3.2. AF LED/Mic Schematic Diagram ........................................... S-4
S3.3. CCD Flex Schematic Diagram .............................................. S-4
S3.4. Lens Flex Schematic Diagram .............................................. S-5
S4. Print Circuit Board .................................................................... S-6
S4.1. AF LED/Mic P.C.B. ................................................................ S-6
S4.2. CCD Flex P.C.B. .................................................................... S-6
S4.3. Lens Flex P.C.B. .................................................................... S-7
S5. Replacement Parts List ............................................................ S-9
DSC0701009CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S6. Exploded View ....................................................................... S-15
S6.1. Frame and Casing Section (1) ............................................ S-15
S6.2. Frame and Casing Section (2) ............................................ S-16
S6.3. Packing Parts and Accessories Section .............................. S-17
S-1
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram.
Name of Signal
HAVE THE SPECIAL CHARACTERISTICS