Reconnect A Headset Or Car Kit; Disconnect From A Bluetooth Device; Send Information Using Bluetooth - HTC Desire 626s User Manual

 Your phone pairs with the headset and the headset connection status is displayed in the Paired
Devices section.
Note: If automatic pairing fails, enter the passcode supplied with your headset.
The pairing and connection status is displayed below the hands-free headset or car kit name in the
Bluetooth phones section. When the Bluetooth headset or car kit is connected to your phone, the
Bluetooth connected icon

Reconnect a Headset or Car Kit

Normally, you can easily reconnect your headset by switching on Bluetooth on your phone, and then
turning on the headset. However, you might have to connect manually if your headset has been used with
another Bluetooth device.
Important: Make sure that the headset is discoverable. Refer to the headset manual for details.
1. Swipe down from the status bar and tap
2. Tap the headset's name in the Paired Devices section.
3. If prompted to enter a passcode, try 0000 or 1234, or consult the headset/car kit documentation
to find the passcode.
If you still cannot reconnect to the headset or car kit, follow the instructions in
Bluetooth Device, and then follow the steps in

Disconnect From a Bluetooth Device

If you do not need to use Bluetooth at any given point, you can disconnect and unpair your phone from a
Bluetooth device.
1. Swipe down from the status bar and tap
2. In the Paired Devices section, tap
3. Tap Unpair.
Note: Tap the name of the device to reconnect it.

Send Information Using Bluetooth

You can use Bluetooth to transfer information between your phone and another Bluetooth-enabled device
such as a phone or computer. The first time you transfer information between your phone and another
phone, you need to enter or confirm a security passcode. After that, your phone and the other phone are
paired, and you will not need to exchange passcodes to transfer information in the future.
Important: Before you begin, set the receiving phone to discoverable mode. You may also need to set it
to "Receive Beams" or "Receive Files." Refer to the phone's documentation for instructions on receiving
information over Bluetooth.
Connectivity
is displayed in the status bar.
> Bluetooth.
Connect a Bluetooth Headset or Car
> Bluetooth.
next to the device to unpair.
Disconnect From a
Kit.
198