Setting The Network Camera Over The Lan - Panasonic A14 Quick Start Manual

Network Dome Camera Quick Operation Guide
Setting the Network Camera over
the LAN
Purpose:
To view and configure the camera via LAN (Local Area Network), you need to
connect the network camera in the same subnet with your PC. Then install the
iVMS-4200 software to search and change the IP address of the network camera.
The following figure shows the cable connection of a network camera and a PC:
Set the IP address of the camera for accessing via LAN.
Steps:
To set the IP address, please use the Advidia Camera Finder Utility as
described below:

To view and configure the camera via LAN (Local Area Network), you need to
connect the network camera in the same subnet with your PC. Then, install
the Advidia Camera Finder Utility.
Refer to the following introductions to set IP address with the Advidia
Camera Finder Utility software (for more detailed instructions please
Figure 3-1 Wiring over LAN
14