Cleaning & Care; Troubleshooting - Dualit DDP2 Instruction Manual

CLEANING & CARE
1 UNPLUG 2 WIPE
Switch toaster off, remove Wipe the outside of the
the plug from the wall socket toaster with a moist cloth
and let the toaster cool down and dry it with another
before you start cleaning it. cloth. Do not use a
scouring pad or abrasive
cleaner.
4 5
LIGHTLY TAP CRUMB TRAY
When the toaster has Crumbs will accumulate in the
cooled completely, tap the crumb tray and could catch
sides of the toaster lightly to fire if the tray is not emptied
dislodge any crumbs caught frequently. Pull out the crumb
in the toasting chamber. tray and wipe clean using a
damp cloth.
3 CAUTION
Use a soft brush to clean
inside your toaster.
Do not insert any metallic
or sharp utensils in to the
toaster.
6
CORD TIDY
Store the cleaned toaster
unplugged with the cord
wrapped round the cord
tidy on the base of the
toaster.
16

TROUBLESHOOTING

POSSIBLE CAUSE(S)
MY TOASTER IS NOT WORKING:
1. The toaster may not be properly
connected to the power supply.
2. If your lever is not staying down.
3. The toaster may have tripped the
Residual-Current Device (RCD). Some
crumbs or pieces of bread may be stuck in
the toaster.
I GET UNEVEN TOASTING:
1. Different bread types and sizes have
been used at the same time.
2. End elements take a little longer to
warm up than centre elements.
MY TOAST DOESN'T POP UP WHEN THE TOASTER HAS FINISHED:
1. There may be a fault with the toaster.
2. Your bread may be too thick
ONE SIDE OF MY BREAD IS NOT TOASTING
1. If set to Bagel setting only one side will
toast.
SMOKE COMING OUT OF THE SLOTS
1. If this is the first time using your toaster,
this is normal, your elements are being
conditioned.
2. The crumb tray might be full. A build up
of crumbs can burn or cause a fire.
3. Some crumbs or pieces of bread may
be stuck in the toaster.
Please note: The heating elements in this toaster are non replaceable.
TO REPLACE FUSE,
REMOVE SILVER LABEL
TO ACCESS SCREW.
SOLUTION(S)
1. Check the plug is in the socket and the switch
is turned on.
2. Check if the power neon is illuminated.
If yes, unplug the toaster and call service centre
If no, your plug fuse may have blown.
3. Unplug, and allow to cool. Remove the
crumb tray then turn the toaster upside down
over a bin and gently shake the crumbs out.
1. Ensure size and type of bread being toasted
is the same.
2. Once toaster is at optimum operating
temperature this will no longer occur.
1. If the power neon remains illuminated,
immediately unplug the toaster and call service
centre.
2.1 Slices thicker than 36mm will get stuck.
2.2 Hand cut slice must be cut evenly.
2.3 Using a 'sandwich cage' can make toasting
thicker items easier.
1. Press the bagel button to cancel the setting.
Remember to insert bread from the very left
hand slot.
1. This will dissipate after a few uses.
2. Empty the crumb tray.
3. Unplug, remove the crumb tray then turn
the toaster upside down over a sink or bin and
gently shake the crumbs out.
17