Alarm Report; Npc (Nuisance Prevention Circuitry) - Viper 5606V Owner's Manual

Hide thumbs Also See for 5606V:
Table of Contents

Advertisement

Alarm Report

If the alarm was triggered while armed, it will be reported when the
alarm is disarmed via siren chirps, parking light and Control Center
LED flashes. The siren chirps four times (or five times if NPC is ON*),
the parking lights flash three times, and the control center LED flashes
in groups to indicate the last two zones that were triggered (see Table
of Zones). The report output will repeat for each disarm operation until
the ignition is turned on.

NPC (Nuisance Prevention Circuitry)

* See
Zone # (led flashes)
1
2
3
4
5
6
NPC (Nuisance Prevention Circuitry)
NPC monitors all alarm zones and, if any are triggered excessively,
bypasses them until corrected. If a point of entry (trunk, hood, door)
is left open following a forced entry, it is bypassed. It becomes active
again only after being closed.
Bypassed sensors automatically reset after one hour and after the
vehicle is driven. Disarming then re-arming the alarm does not reset
bypassed sensors.
20
Table of Zones
Zone Name
Trunk
Shock Sensor
Door
Sensor 2
Ignition
Hood
for more details.
© 2016 Directed. All rights reserved.

Advertisement

Table of Contents
loading

Table of Contents