Hotpoint RK962G Use And Care Manual page 33

Microwave Oven
I
PROBLEM
CONTROL PANEL
ON, YET OVEN WILL
OVERCOOKED
FOODS
OR UNDERCOOKED
MICROWAVE OVEN
FAN COMES ON
WHEN OVEN IS OFF
"PROBE" APPEARS
ON DISPLAY
"ERROR" APPEARS
ON DISPLAY
Conventional Oven
PROBLEM
OVEN WILL
OVEN LIGHT
DOES N~ WORK
TOUCH PADS
WILL NOT WORK
POSSIBLE CAUSE AND REMEDY
START pad not touched.
Door not securely closed.
Another function was touched. Touch CLEAR/OFF pad to cancel.
Numbers not entered after touching TIME COOK pad.
. Finished temperature not entered afier entering Auto Roast code 7.
CLEAR/OFF pad touched accidentally.
. No code number entered after touching AU~ ROAST or AU~ DEFROST pad.
Not
enough time set when using Time Cook function because starting temperatures
of foods varied widely.
Varying density and amount of foods will sometimes require more cooking time.
Probe not inserted properly into meat or dish. Check cookbook or Auto Roast section
of this book.
. Incorrect power level entered.
Dish not rotated, turned or stirred as called for in recipe.
dishes in oven at same time.
Too many
Food not thoroughly defrosted.
Improper use of coverings. Check cookbook and this book for instructions.
Microwave Oven fan is used during self-cleaning of Conventional Oven to keep
components cool. Microwave power is not on.
. Probe not inserted properly into oven receptacle or food.
Probe not used, although AU~ ROAST pad has been touched.
of less than 80°F. or more than 199°F.
1
POSSIBLE CAUSE AND REMEDY
Difficulty may be in the main distribution panel of your house by a blown oven
circuit fuse, a tripped oven circuit breaker, the main fuse or the main circuit breaker,
depending on the nature of the power supply. If a circuit breaker is involved, reset it. If
the control box uses fuses, the oven fuse (a cartridge-type) should be changed BUT
ONLY BY SOMEONE FAMILIAR WITH ELE~~CAL CIRCUITS. If, after doing
one of these procedures, the fuse blows or circuit breaker trips again, call for service.
NOTE: Apartment tenants or condominium owners should request their building
management perform this check before calling for service.
Oven controls not properly set.
Door left in locked position after cleaning.
Light bulb is loose or burned out.
Button operating oven light is defective.
Clock not set. Touch CLOCK pad and enter time.
(continued next page)
33