Connecting The Tv To A Pc; Using Side Av Connectors; Input Selection - Finlu 19H6030S Owner's Manual

• Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
• Multipartiton support is available. Maximum two
different partitions are supported. If the disk have
more than two partitions, crash may occur. First
partition of the usb disk is used for PVR ready
features. It also must be formatted as primary
partition to be used for PVR ready features.
• Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
• Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.
• Radio record is not supported.
• The Tv can record programmes up to ten hours.

Connecting the TV to a PC

For displaying your computer's screen image on your
TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use a 15-pin D-sub display cable
to connect a PC to the TV. When the connection is
made, switch to PC source. See the Input selection
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix.
PC VGA Cable
(Not supplied)
PC Input
(back)
Side Audio/Video
Connection Cable
(Supplied)
Side AV Input
Note: If you connect a PC to the TV using HDMI
connection, radio interference may occur. Therefore
this type of connection is not recommended. You
should use VGA connection instead.
MB62_[GB]_(01-TV)_woypbpr_IDTV_PVR_NICKEL17_5110UK_19965LED_10073978_50192728.indd 12 MB62_[GB]_(01-TV)_woypbpr_IDTV_PVR_NICKEL17_5110UK_19965LED_10073978_50192728.indd 12
You can connect a range of optional equipment to your
TV using the side connectors of the TV.
•
•
•
Once you have connected external systems to
your TV, you can switch to different input sources.
Press "SOURCE" button on your remote control
consecutively for directly changing sources.
Or
PC Audio Cable
(Not supplied)
Note: YPbPr mode can be used only when you
connect a device that has a YPbPr output through the
PC input with YPbPr to PC cable (not supplied).
- 12 -

Using Side AV Connectors

When connecting a camcorder or camera , you should
use the SIDE AV socket. To do this, you must use the
supplied video/audio connection cable. First, plug
single jack of the cable to the TV's AV IN socket
(side). Afterwards, insert your camera cable's (not
supplied) connectors into the plural part of the video/
audio connection cable. Colours of the connected
jacks should match. See illustration below.
Afterwards, you should switch to the
See the section Input selection in the following
sections for more information.
To listen the TV sound from headphones, you
should connect headphones to your TV by using the
HEADPHONE jack as illustrated above.

Input Selection

(optional)
Side AV source.
07.09.2011 11:52:29 07.09.2011 11:52:29