Table of Contents
Advertisement
SPORTSART E81 ELLIPTICAL TRAINER
TABLE OF CONTENTS
1. INTRODUCTION...................................................................................................
2. SAFETY GUIDELINES .........................................................................................
List of parts............................................................................................................
Step by Step Instructions.......................................................................................
Display Layout......................................................................................................
Display Specifications..........................................................................................
Display Controls...................................................................................................
Default Value........................................................................................................
Keypad.................................................................................................................
Program Overview...............................................................................................
Glute....................................................................................................................
WT Loss (HRC 65%) / Cardio (HRC 80%)...........................................................
Pause..................................................................................................................
END OF WORKOUT............................................................................................
5. Fuse Replacement...............................................................................................
6. WIRING SCHEMATIC..........................................................................................
1
2
3
5
12
12
13
15
15
16
17
17
18
18
19
20
Advertisement
Table of Contents
Related Manuals for SPORTS ART E81
Summary of Contents for SPORTS ART E81
-
Page 1: Table Of Contents
SPORTSART E81 ELLIPTICAL TRAINER TABLE OF CONTENTS 1. INTRODUCTION....................2. SAFETY GUIDELINES ..................3. ASSEMBLING YOUR ELLIPTICAL TRAINER List of parts......................Step by Step Instructions..................4. E81 DISPLAY Display Layout...................... Display Specifications..................Display Controls....................Default Value......................Keypad......................... Program Overview....................Glute........................ -
Page 2: Introduction
Congratulations on purchasing one of the finest piece of exercise equipment on the market today, the Sports Art E81constructed of high quality materials and designed for years of trouble-free usage, the Sports Art E81 will be an integral part of your fitness regimen. -
Page 3: Safety Guidelines
Keep this owner s manual for future use and reference. • Read this owner s manual and follow the instructions. • Assemble and operate the Sports Art E81 Elliptical Trainer on a solid, level • surface. Never allow children on or near the machine. -
Page 4: Assembling Your Elliptical Trainer
ASSEMBLING YOUR ELLIPTICAL TRAINER Thank you for purchasing this product. We go through great efforts to ensure the quality of each product. If you find this product to be defective in any way, please contact SportsArt or your dealer. Note that some parts may get mixed amongst packaging material during shipment. Please locate all the parts first before you discard the packaging material. - Page 5 1. Left vertical arm + shoulder covers A/B 2. Right vertical arm + shoulder covers A/B 3. Stride rail front covers A/B/C/D 4. Pedestal base cover 5. Stride rail rear cover (left) 6. Stride rail rear cover (right) 7. Left footplate 8.
-
Page 6: Step By Step Instructions
ELLIPTICAL ASSEMBLY Frame assembly STEP 1. Route the data cable as shown. Note the position of (A) in the illustration above. Then place the pedestal tube onto its base. Use a 6mm Allen wrench to secure the screws and washers in the following order: (B), then (C) and (D). - Page 7 STEP 5. Before assembling the product, remove the shoulder covers. Set (a) flat washer and (b) wave washer in place on the arm axle. Put the left vertical arm in place. Put (c) washer in place and secure (d) screw with a 6mm Allen wrench.
- Page 8 STEP 7. Put the stride rail on the roller under the vertical arm as shown in illustration 1. STEP 8. Use a Allen wrench (5mm) to loose the screw (a). Pull outward the adjust linkage, but do not take it out. Put the adjust linkage in place in alignment with vertical arm bolt.
- Page 9 STEP 9. Assemble stride rail front covers in the order of A, B, C, D. Secure screw (a) first. A: Stride rail front cover A B: Stride rail front cover B C: Stride rail front cover C D: Stride rail front cover D a: Phillips screw (M5*P0.8*15) Fig.5 Fig.6...
- Page 10 STEP 10. First, install (d) stride rail inner cover and secure it with screw (a). Then install cover (c) and secure it with screw (b). a. Phillips head screw (M5*P0.08*15) b. Phillips head screw (M5*P0.08*15) c. stride rail rear cover (left) d.
- Page 11 STEP 11. Assemble the foot pedals onto the rails, using screws and washers to secure them. The sides without walls should face outside. a. flat washer (D20*d5*t10) b. spring washer (M5) c. mushroom top inner hex screw (M5 P0.8 L10) d.
-
Page 12: Connect To Power
FOOT LEVEL ADJUSMENT STEP 1. If the unit rocks or is not level, adjust levelers at the front of the unit. First, adjust the foot (A), then secure it in place by tightening washer (B) against the frame, as shown. Fig.9 Connect to Power The power socket is at the lower rear part of the elliptical trainer. -
Page 13: E81 Display
E81 DISPLAY Display Layout Dot Matrix Display Workout feedback windows include: WORKOUT LEVEL, HR; TIME, TOTAL STRIDES; STRIDES/MIN, CALORIES; DISTANCE, WATTS. DISPLAY SPECIFICATIONS WORKOUT LEVEL (Level of resistance): 1 ~ 14 WATT: 0~9999 TIME: 0 00 99: 59 (Range from 5:00 ~ 99:00) ：... -
Page 14: Display Controls
、 Display Controls Starting Display: When the machine first starts up, the dox matrix window shows "E81". 1. QUICK START Press the QUICK START key to immediately start exercising. Time accumulates from 0:00. If entering QUICK START mode, the "TRACK LED" lights and TRACK workout mode begins.(Time counts up from 0:00.) - Page 15 3. START A. USER setting After turning on the equipment, press the START key, the USER LED lights up. "1" appears in the dot matrix window. Press to view users: Pressing up ▲ ▼ produces USER 1 USER 2 USER 3 USER 4 USER 1 USER 2...
-
Page 16: Default Value
Default Value 1. Total distance In the user mode, press WORKOUT LEVEL + WORKOUT LEVEL for three ▼ ▲ minutes. Total distance appears as eight digits across the time and distance windows. Distance units, MILE or KM, appear in the Dot Matrix window. Press ENTER to proceed to total time. -
Page 17: Program Overview
(2) While in the user window, pressing the QUICK START key makes the display show the user's exercise program and workout time. If the previous user didn't exercise in any program, TRACK mode and a workout time of 30 minutes will appear. -
Page 18: Glute
3. The dot matrix window shows the message "ENTER WORK TIME. " The Time Window lights up. Press WORKOUT LEVEL to establish the ▲ ▼ workout time. Press the ENTER key to confirm your choice. 4. The dot matrix window shows the message " ENTER WORK LEVEL." Workout Level Window lights up. -
Page 19: Pause
3-1. (1) Flash heart figure. (2) Target heart rate. (3) Actual RPM (4) Suggested RPM. 3-2. Preset values is SPM. These programs will detect the user's heart rate and adjust resistance levels accordingly. 3-3. If the user stops exercising, "STEP TO START" appears twice on the dot matrix display. -
Page 20: Fuse Replacement
Fuse Replacement: If you turn on the unit but the display does not light up, it may be necessary to replace a fuse. STEP 1. Identify the fuse specification. Use the appropriate type of fuse. STEP 2. To remove an old fuse, push the fuse cap in and turn counterclockwise. STEP 3. -
Page 21: Wiring Schematic
WIRING SCHEMATIC Your Authorized SPORTS ART Distributor...