Pioneer PD-F1007 Service Manual page 49

6 Remove the screws E (4 screws), and then remove the Disc Guard.
7 Remove the Float Base Assy and Clamp Holder.
Disc Guard
Front
8 Remove the Flexible Flat Cable
and the Connector Assy (4P)
from the Float Base.
9 Remove the screw G.
0 Remove the float spring.
(To install this part, line up the
float angle side of the Servo
Mechanism ASSY GM first, and
press down on the float base side.)
- Remove the float rubber from
the Servo Mechanism ASSY
GM. At this time the Float
Rubber should remain on the
Float Base side. (To install it on
the Float Base when it has been
removed, push it into place with
a thin cylindrical object.
6
Float Base Assy
Screw E
(× 4)
Float Base Assy
10
Float Spring
8
Connector Assy (4P)
7
Clamp Support
Front
8
Flexible Flat Cable
Screw G
9
PD-F1007
Clamp Holder
7
Clamp
Spring
Float Base
Float
Rubber
11
Servo Mechanism
Assy GM
49