LOCKEY 2210 Installation Instructions

No. Part Name
1 Outside Body
2 Inside Body
3 Adjustable Deadbolt (2 3/8" – 2 3/4")
4 Rubber Trim Plate
5 Strike Plate
6 Mortised Striker
7 Spindle 40-55 mm.
8 Spindle 30-45 mm.
9 Machine Screw M4 x 50 mm.
10 Machine Screw M4 x 35 mm.
11 Wood Screw M4
12 Non-Combination Tumbler
13 Combination Tumbler
14 Brass Support Pin
15 Tweezers
Step 1: Change User Code (OPTIONAL)
If you wish to change your code, see instructions on reverse side.
Step 2: Prep Door for Installation with Template
1. Place template (supplied) on door and fold along door's edge.
2. Mark holes for 2 3/8" or 2 3/4" backset.
3. Drill holes as instructed.
NOTE: For Pre-Prepped 2 1/8" doors, you only need to drill top hole.
Step 3: Identify Door Handing
Right-Hand Doors – From exterior of
door, hinges are on right-side. (Fig. 1)
Left-Hand Doors – From exterior of
door, hinges are on left-side. (Fig. 2)
The 2210 is factory pre-handed for
right-hand doors. To change handing, remove two
blue screws and cover plate from Outside Body.
Now, move the pin from the right side of the
outside body to the hole on the left side. Replace
plate and screws.
*2210 DC – Inside Body handing pin must be
placed on opposite side from Outside Body.
Step 4: Install Support Pin & Hex Bolts
Install Brass Support Pin (#14) into either hole
on Outside Body as shown in the figure to
the Right [Left].
Install/screw Hex Bolts into the top
and bottom of the Outside Body
as shown in the figure (Far Right).
DIGITAL 2210 Deadbolt
Installation Instructions
2210 | 2210 DC
2210
1
1
1
2
1
1
2
2
4
1
2
1
3
2
1
Step 5: Adjust Deadbolt (if necessary) & Install
1. Adjustable Deadbolt (#12) is preset to 2 3/8".
2. With arrow pointed UP, insert Deadbolt
Step 6: Verify Correct Spindle Length
1. With deadbolt (#3) installed, hold
2. Place Spindle (#7/8) through Deadbolt,
3. Spindle should extend from exterior of door
4. If the 30-45 mm (#8) is too long, cut it to the correct length.
IMPORTANT: If spindle extends less than 3/8" it may not engage the lock. If spindle
extends more than 5/8", it will cause the lock to bind.
Step 7: Install the DIGITAL 2210
5. Place the Rubber Trim Plate (#4) on the
6. Place the Outside Body
7. The Support Pin (#14) on the Inside
To adjust, lift pin and slide to 2 3/4".
and secure with two (2) Wood Screws (#11).
the Inside Body (#2) and Rubber Trim
Plate (#4) to the door.
into the Inside Body, as far as possible.
3/8" min. – 5/8" max.
backside of the Outside Body (#1).
on the door. The hexagonal
bolts should extend into
the top and bottom holes.
Body should fit into and extend through
the hole in the Deadbolt (#3).
INSTRUCTIONS CONTINUED ON REVERSE SIDE
Adj. Pin
2 3/8"
2 3/4"
Door Edge
Inside Body (#2)
3/8" to 5/8"
Inside Knob
Spindle (#5/6)