Chronometer Screen Page; Chronometer Operation Logic - Ferrari 2012 F12 Berlinetta Owner's Manual

Chronometer screen page

The "Chronometer" screen page is used to time laps and memorise
lap time if the vehicle is used on track. The screen page displays the
following information:
Current Lap
indicates the time elapsed since the start of the chronometer
LAP TIME / Best
indicates the time required to complete the last best lap
LAP TIME / Last
indicates the time required to complete the last lap
TOP SPEED / Best
indicates the maximum speed reached
TOP SPEED / Last
indicates the maximum speed reached in the last lap.
If the "Chronometer" screen page is being displayed and an event
occurs that needs to be displayed as a symbol and/or special
message, the screen page is minimised. For further information,
refer to the "Fault visualisation logic" paragraph on page 106.
Current LAP
1:12:10
About your Vehicle
96
LAP TIME LAP TIME
Best: 1:11:00
Last: 1:14:40
TOP SPEED TOP SPEED
Best: 247
Km/h
Last: 230
Km/h
During display of the event/malfunction, the chronometer remains
active.
Each time the key is turned to on, the chronometer is reset whereas
the last valid Best Lap and Last Lap information is memorised.

Chronometer operation logic

The chronometer is controlled using the OK, UP and DOWN
buttons that perform the following functions:
- Pressing and quickly releasing the OK button:
when the chronometer is off, starts the Current Lap chronometer
when the chronometer is on, resets and restarts the Current Lap
and updates the information on previous laps (end of lap/start of
next lap)
- Pressing and quickly releasing the UP or DOWN button:
when the chronometer is on, stops the chronometer and updates
information on previous laps
when the chronometer is off, displays the screen page for adjusting
display brightness
- Holding down the UP or DOWN button:
when the chronometer is on or off, resets the chronometer and
information on previous laps.
Note that during display of an event/malfunction, pressing and
quickly releasing the OK button interrupts the event/malfunction
display cycle ("ESCAPE" function), without affecting the
chronometer.