Table of Contents
Advertisement
Software Components
N o t e
Updating Switch Software
The HP Advanced Services zl Module with Microsoft® Windows Server®
requires switch software version K.14.65 or later to be installed in the switch.
Version K.15.03 or greater is recommended if the module is installed in an HP
E8200 zl switch with dual management modules. K.15.03 will gracefully shut-
down and restart the module in the event of a management module failover.
(Version K.14.65 will shut down the module, crashing the Windows OS.) When
an update is needed, use the following steps to update the switch software:
1.
Visit the HP Web portal at
number of the latest module-compatible software.
2.
Check the version number of the software installed on the switch.
Connect to the switch CLI and use the following command:
hostzlswitch# show version
Image stamp: ...
Boot Image: Secondary
3.
If the switch software is out-of-date, update it:
hostzlswitch# copy tftp flash <source><source
filename> secondary
hostzlswitch# startup-default secondary config <config
filename>
hostzlswitch# boot system flash secondary
If a CLI command must be aborted, use either Ctrl-C or Ctrl-Z. The difference
between using the two is that Ctrl-Z, unlike Ctrl-C, does not provide any
message indicating that the command was aborted.
There are some conditions when Ctrl-C may not work; in these cases, use
Ctrl-Z.
www.hp.com/networking
<date, time>
K.14.65
...
Software Components
Updating Switch Software
D
to check the version
D-1
Advertisement
Table of Contents
