Capital Sirius 490MF Installation And Operating Instructions Manual page 22

Inner Grate Removal and Replacement
Lift the inner grate vertically until it clears
the locating pin of the riddling mechanism
housed in the ash pan chamber, then
manoeuvre the grate out of the stove.
When replacing, ensure the slot engages
with the pin.
Outer Grate Removal and Replacement
Remove all the bricks and the inner grate. Lift the outer grate up at an angle left
higher than right and manoeuvre the grate out left side first. There is always a
knack to such a task, but it is easy once learnt!
Stove Body
The stove is finished with a heat‐resistant paint and this can be cleaned with a
soft brush. Do not clean whilst the stove is hot, wait until it has cooled down.
The finish can be renovated with Capital stove paint available from your
supplier.
Glass Panels
Clean the glass panels when cool with Capital glass cleaner. Highly abrasive
substances should be avoided as these can scratch the glass and make
subsequent cleaning more difficult. Wet logs on heated glass, a badly aimed
poker or heavy slamming of doors could crack the glass panels. The glass will
not fracture from heat.
Should a glass panel require replacement,
then remove the four screws and clips
retaining the glass frame, carefully remove the
broken glass and replace the panel with the
correct stove glass from your supplier. Ensure
you use new glass fibre seal around its edge,
and use the steel frame, clips and screws to
retain it in position.
Sirius MF&WD Version 1 November 2013