Lattice Installation
Remove the glass panel as shown on page 20 and locate the lattice in place from
the back of the door. Ensure that the steel tabs are located against the window
frame and the heat resistant pads are in place over the steel tabs to protect the
glass panel. Replace the glass panel as described on page 20.
Top or Rear Flue
Remove the collar and accessory pack from the stove. The stove will arrive with
the blanking plate fitted to the rear. This can be removed if required allowing
the collar to be fitted for rear flue installations. The circular cut out in the rear
heat shield must be removed to enable this style of connection – see image
below.
Sirius 790 Sigma MF shown
Sirius MF&WD Version 1 November 2013
Remove the panel from the stove
by unscrewing the four screws and
then remove the circular cut out
for rear flue installations. Replace
the rear heat shield.
Remember to fit the blanking plate
to the unused flue position if it has
been removed.