System Setting; Wired Network Connection; Wired Network Setup - LG HR835T Simple Manual

2

System Setting

12 System Setting

Wired network connection

Connect the unit's LAN port to the corresponding
port on your Modem or Router using a
commercially available LAN or Ethernet cable (CAT5
or better with RJ45 connector). In the example
configuration for wired connection below, this
player would be able to access content from either
of the PCs.
Router
2
WAN
LAN 1
LAN 2
LAN 3
Broadband
Service
PC
PC
LAN Cable
Rear of this unit

Wired Network Setup

If there is a DHCP server on the local area network
(LAN) via wired connection, this player will
automatically be allocated an IP address. After
making the physical connection, a small number of
home networks may require the player's network
setting to be adjusted. Adjust the [NETWORK]
setting as follow.
Preparation
Before setting the wired network, you need to
connect the broadband internet to your home
network.
1. Select [Connection Setting] option in the
[Setup] menu then press ENTER (b).
2. Use w/s/a/d to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
,
Note
If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using w/s/
a/d and numerical buttons. If you make a
mistake while entering a number, press CLEAR
to clear the highlighted part.