Optional Accessories; Protecting The Environment - DeWalt DW343 Original Instructions Manual

EN GLI SH
5. For cutting perfectly round shapes, install the
trammel bar and set it to the required radius
(fig. 10).
Sawing Up to a Projecting Edge
(fi g. 1, 11)
1. Using a conventional blade, cut up to the
projected edge.
2. Finish off the cut using a flush cutting blade.
Dust Extraction (fi g. 5)
When the tool is used indoor for extended periods
of time, use a suitable dust extractor designed in
compliance with the applicable Directives regarding
dust emission.
Sawing in Metal
1. Mount an appropriate saw blade.
2. Proceed as described above.
WARNING: Use a cooling lubricant
(cutting oil) to prevent overheating of
the saw blade or the workpiece.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
Lubrication
Your power tool requires no additional lubrication.
Apply a drop of oil to the guide roller (h) at regular
intervals to prevent jamming.
30
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
These include:
– DE3241 Parallel guide
– DE3242 Trammel bar
– DT2048 Fine toothed cutting blade
– DT2075 Coarse toothed cutting blade
– DT2160 Metal cutting blade
– DT2074 Flush cutting blade

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
WALT, have
E
WALT product
E