Important Safety Instructions; Drying Guide - Simpson EZIloader Instruction Booklet

Important Safety Instructions

LINT BUILD-UP IS A FIRE HAZARD
A clean lint filter reduces drying times, saves energy and
avoids overheating. Overheating may also damage your
clothes.
What happens if I forget to clean the lint filter?
Drying Time
tripled
doubled
normal
1 5
Number of usages with an unclean lint filter
(based on laboratory tests using a load of new towels)
The lint filter is located
at the front of your
dryer at the bottom
of the door opening.
You must clean this lint filter after every load.
Open apart the lint filter and
wipe or peel off the lint.
Ensure the lint filter 'clicks' when replacing. It can be inserted
into the pocket either way.
!
Never operate your dryer without the lint filter.
!
Do not allow lint to build up around your dryer.
!
A torn or damaged lint filter must be replaced
immediately.
!
Overloading can increase lint build-up because the
airflow is reduced.
To avoid potential fire hazards, we recommend that you
pay a qualified service technician to periodically clean
your dryer. You must do this also when you change your
mounting from upright to inverted, or vice versa.
9
remove the lint filter open
To remove the lint filter
the door and press the two
open the door and press
pads together. Pull the lint
the two pads together.
filter out of the pocket.
Pull the lint filter out of
the pocket.

DRYING GUIDE

Your load, when dry must not exceed the rated capacity.
!
4kg for the 4kg Machine
!
5kg for the 5kg Machine
!
6kg for the 6kg Machine
(See page 6 for a table of average weights of laundry items)
Always check your labels for the drying symbols which the
International Care Labelling Code now uses.
May be tumble dried
Do Not Tumble Dry
!
Permanent press and synthetics
the dryer stops to reduce wrinkles.
!
Woollen articles
original shape, then dry them flat.
!
Woven and loop knit materials
amounts, depending on their quality. Do not use the 'hot'
setting for these fabrics. Always stretch them out
immediately after drying.
!
Fibre or leather materials
manufacturer's instructions.
LINT
FILTER
!
Baby clothes and night gowns
sleepwear use only on the 'warm' setting.
!
Rubber and plastics
or containing rubber or plastics, such as aprons, bibs,
babies' waterproof napkins, curtains, tablecloths,
shower caps, clothes fitted with foam rubber pads,
pillows, galoshes, or rubber coated tennis shoes.
!
Fibreglass
dryer could be picked up by your clothes the next time
you use the dryer, and irritate your skin.
During the drying cycle, if you want to
!
add or take out clothes, or
!
check the dryness of the load,
turn down the timer to 'Airing' for at least one minute before
opening the door. This is to prevent scorching or possible self
combustion of the fabric.
Fabric softeners or similar products should not be used in a
tumble dryer to eliminate the effects of static electricity
unless this practice is specifically recommended by the
manufacturer of the fabric softener or product.
Note: We strongly advise against the use of fabric
conditioners of the sheet type that are added to the
clothes in the drum. These products may lead to rapid
blockage of the lint filter and inefficient operation of your
dryer.
3
Normal drying (high temperature)
Delicate drying (low temperature)
- take out as soon as
- not recommended. Pull them to their
- may shrink, by varying
- always check the
- acrylic clothing or
- Do not dry any items made from
- not recommended. Glass particles left in the