Troubleshooting - Fellowes POWERSHRED 125i Manual

Hide thumbs Also See for POWERSHRED 125i:
Table of Contents

Advertisement

Available languages

Available languages

PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug
Locate Auto-start
shredder
infared sensor
OILING SHREDDER
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
AUTO
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
PREVENTIVE MAINTENANCE & ACCESSORIES

TROUBLESHOOTING

A
B
C
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
.
4
3
Dip cotton swab in
rubbing alcohol
away any contamination
from the paper sensors
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
B. Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the
D
E
C. Bin Full Indicator:
D. Remove Paper Indicator: When illuminated, press reverse (
E. SafeSense
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
door to resume shredding.
waste bag 36054.
Indicator: If hands are too close to the paper entry, the SafeSense
®
and the shredder will stop shredding. If SafeSense
turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (125Ci only).
ENGLISH
Models 125Ci/125i
) and remove paper.
®
indicator will illuminate
®
is active for 3 seconds, the shredder will automatically
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powershred 125ci

Table of Contents