Presser Bar Height And Allignment - Janome 4052lx Service Manual

PRESSER BAR HEIGHT AND ALLIGNMENT

TO CHECK:
1. RAISE THE PRESSER FOOT LEVER (B).
2. THE DISTANCE BETWEEN THE PRESSER FOOT (A) AND THE NEEDLE PLATE (C) SHOULD BE
6.0 MM (0.24").
IF THIS IS NOT THE CASE, ADJUST AS FOLLOWS.
ADJUSTMENT PROCEDURE:
1. REMOVE THE FACE COVER. RAISE THE PRESSER FOOT LEVER (B) AND LOOSEN THE
SETSCREW (D) ON THE PRESSER BAR HOLDER (E).
ADJUST THE DISTANCE BETWEEN THE PRESSER FOOT AND THE NEEDLE PLATE TO 6.0 MM
(0.24").
2. TIGHTEN THE SETSCREW (D) SECURELY.
3. ATTACH THE FACE COVER.
NOTE:
WHEN YOU TIGHTEN THE SETSCREW, MAKE SURE THAT BOTH SIDES OF THE PRESSER FOOT ARE
PARALLEL TO THE FEED DOG SLOTS (F) ON THE NEEDLE PLATE.
PRESSER BAR HOLDER (E)
SETSCREW 4 X 8 (D)
<HEIGHT OF PRESSER FOOT>
N E E D L E
PLATE (C)
B
MECHANICAL ADJUSTMENT
PRESSER FOOT (A)
A
A
C
6.0 mm
FEED DOG
10
PRESSER FOOT LEVER (B)
<PRESSER FOOT ALIGNMENT>
FEED DOG SLITS (F)
SHOULD BE PARALLEL