Advertisement
158669-01/Feb95
5/17/02
Anvil with Detent Pin
To install a socket on the anvil, align the hole in the side of the socket
with the detent pin on the anvil. Press the socket on until the detent pin
engages in the hole. To remove a socket, depress the detent pin
through the hole, using a small, pointed object, and pull the socket off.
Anvil with Hog Ring
To install a socket on the anvil, push firmly. To remove a socket, pull
firmly.
Impact Time
Many variables exist that will cause the torque available on any fastener
to vary considerably. The optimum impact time is about 6 seconds.
Capacity
1/2" impact wrenches use sockets with 1/2" square drive ends and 3/4"
impact wrenches use sockets with 3/4" square drive ends. Both sizes of
impact wrenches are capable of driving the same range of hex impact
sockets available.
In particularly heavy duty usage the 3/4" drive impact wrench has an
extra strong anvil that will resist breakage.
Important
To assure product safety and reliability, repairs, maintenance and
adjustment should be performed by D
or other qualified service organizations. These service organizations
service D
WALT tools always using D
E
Black & Decker (U.S.) Inc. industrial tool service centers are certified to
service D
WALT industrial tools.
E
Lubrication
Your tool was properly lubricated before leaving the factory. In from two
to six months, depending upon use, take or send your tool to a Black &
Decker (U.S.) Inc. Industrial Service Center or other qualified service
organization for a complete cleaning, inspection and relubrication.
Tools used constantly on production or heavy duty jobs or exposed to
heat may require more frequent lubrication. Tools "out of service" for
long periods should be relubricated before being put back into service.
3:20 PM
Page 7
(DW290 & DW296 only)
(DW291 only)
WALT certified service centers
E
WALT replacement parts.
E
Accessories
Recommended accessories for use with your tool are available at extra
cost from your local service center. CAUTION: The use of any non-
recommended accessory may be hazardous.
NOTE: Use only impact sockets. Non-impact sockets may break and
cause a hazardous condition.
A complete listing of service centers is included on the owner's
registration card packed with your tool.
If you need assistance in locating any accessory, please contact
D
WALT Industrial Tool Company, P.O. Box 158, 626 Hanover Pike,
E
Hampstead, MD 21074 or call 1-800-4-D
Full Warranty
D
WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. Arrangements have been made with
the Industrial Tool Division of Black & Decker (U.S.) Inc. to provide
warranty repairs for D
WALT tools. Please return the complete unit,
E
transportation prepaid, to any Black & Decker (U.S.) Inc. Industrial
Service Center or Authorized Service Station listed under "Tools,
Electric" in the Yellow Pages. This warranty does not apply to
accessories or damage caused where repairs have been made or
attempted by others. This warranty gives you specific legal rights and
you may have other rights which vary from state to state.
In addition to the warranty, D
E
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
DeWalt heavy duty industrial tool, simply return it to the participating
seller within 30 days for a full refund. Please return the complete unit,
transportation prepaid. Proof of purchase may be required.
See 'Tools-Electric'
– Yellow Pages –
for Service & Sales
3
WALT (1-800-433-9258).
E
WALT tools are covered by our:
Advertisement
