Control Panel - Zanussi zft11110wa User Manual

immediately to the place you bought it. In that
case retain packing.
• It is advisable to wait at least four hours be-
fore connecting the appliance to allow the oil
to flow back in the compressor.
• Adequate air circulation should be around
the appliance, lacking this leads to overheat-
ing. To achieve sufficient ventilation follow
the instructions relevant to installation.
• Wherever possible the back of the product
should be against a wall to avoid touching or
catching warm parts (compressor, condens-
er) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.

Control panel

1 2
Green On/Off Indicator Light
1
Temperature Regulator and On/Off Switch
2
Yellow Fast Freeze Indicator Light
3
Acoustic Signal Stop and Fast Freeze
4
Switch
Red Alarm Indicator Light
5
Switching on
1. Allow the appliance to stand for 4 hrs after
installation.
2. Insert the plug into the wall socket.
4
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-
ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, es-
pecially at the rear near the heat exchanger.
The materials used on this appliance marked by
the symbol
3 4
3. Turn the Temperature Regulator clockwise
to a temperature lower than << - 16 °C
>> position.
4. The Green On/Off Indicator Light will light
up and Red Alarm Indicator Light will blink.
5. The lighting up of the Green On/Off Indi-
cator Light means that the appliance is
switched on.
6. The blinking of the Red Alarm Indicator
Light means an improper temperature in
the freezing compartment. In addition, an
intermittent sound can be heard, which can
are recyclable.
5
www.zanussi.com