Advertisement
1
1. ON / OFF Power switch.
LED indication control. Fully red when switched ON, 50% red when in STANDBY mode
(selected with the Van Medevoort Remote Control). Above the LED you will find the Infra Red
sensor for the Remote Control.
In case of malfunction the power LED will flicker. Turn the amplifier OFF and ON again, with a
5 seconds interval, to reset the amplifier. When the power LED continues to flicker, please
consult your dealer.
2. 1 – 6 Source selector with LED indicators.
These 6 push buttons correspond with the inputs on the backside of the amplifier. The LED's
will go into flickering mode when the signal is switched to MUTE.
3. Volume Control.
Fully anti-clockwise sets the volume at its lowest level. Fully clockwise means that the volume
is at its maximum level. Please be aware that continuous play at this level can cause serious
damage, not only to the amplifier itself but also to any other equipment connected to it.
3
Controls
Precautions
Connections
Maintenance and advice
Technical Specifications
vM MA260 STEREO MAIN AMPLIFIER
2
3
Advertisement
