Code Recall Function; Set-Up By Learning Facility - Wizard 8 way Instruction Manual

TV
(1 sec)
= x2
TV TV TV
=
SHIFT
=
TV
=
&
X
(2 secs)
=
TV
TV
8 8 8 8 1
count
=
1
flashes
count
=
2
flashes
etc.
=
TV
TV
=
&
X
(2 secs)
10. Press the POWER
function keys on your WIZARD.
11. If not all of the keys function correctly, press the lit DEVICE KEY for 1 sec-
ond, the DEVICE KEY will flash once. Repeat from step 8 until you achieve a
satisfactory range of functions on the WIZARD. If you reach the end of your
"device manufacturer library" without finding a suitable code, the DEVICE
KEY will flash twice per second and the set-up mode switches to the LIBRARY
SEARCH mode.
12. When you have found a suitable code, press the DEVICE KEY 3 times until
the DEVICE KEY and STATUS LED go out. The code is then stored.
13. If after you have set-up the WIZARD for your first 4 devices you wish to
set-up additional devices (5-8) follow steps 1-3 then press the SHIFT KEY, the
STATUS LED will change to GREEN, then press a device key and the STATUS
LED will change to RED. You can then set up a SHIFT Mode device by follow-
ing steps 4-12.

Code Recall function

The Code Recall function allows you to directly program into the WIZARD the
exact code for your make and model of device. This is especially useful if
your WIZARD accidentally looses your stored codes. You are advised to write
down the recalled codes in the reserved space on the back of this manual.
The Customer Careline may also need your codes in the event of a problem.
1. Press Power and Mute
(approx. 2 seconds). If you wish to recall the code for a device stored in
SHIFT mode press the SHIFT KEY now.
2. Press required DEVICE KEY. and the DEVICE KEY will light up.
3 Press 8888 plus a digit from 1 to 8. e.g. for TV 88881, for VCR 88882, for
SAT/CATV 88883, for AUX 88884 and for SHIFT TV 88885.
4. For the first digit of your code, press 1 and count the number of times the
STATUS LED flashes on the WIZARD. If the LED does not light up the digit is
zero (duration between flashes is 1 second). To find the 2nd digit of your
code press 2, for the 3rd digit press 3 ,for the 4th digit press 4 and for the
fifth digit press 5 each time count the number of times the LED flashes.
5. Press the lit DEVICE KEY to exit Code Recall mode. The DEVICE KEY will turn
off.

Set-up by LEARNING FACILITY.

To set-up by learning codes you will need a fully functional original remote
control.
Please note that the WIZARD can only learn infrared commands. It is not
compatible with UHF and Ultrasonic remote controls. There are also a number
of infrared remote controls that use encoding methods which the WIZARD
cannot learn.
1. Press the Power
on.
key to turn your device back on and now try other
key together until STATUS LED stays on
and Mute keys together until STATUS LED comes
7