Philips sensotouch wet and dry electric shaver rq1160cc dualprecision blades 2-way flexing heads with precision trimmer and jet clean system (54 pages)
Page 34
English introduction Congratulations on your purchase and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at www.philips. com/welcome. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable.
These Philips appliances comply comply with all standards regarding electromagnetic fi elds (EMF). If handled properly and according to the instructions in this user manual, the appliances are safe to use based on...
Note: If there is a protective foil on the display, remove it before you use the shaver for the fi rst time. The various shaver types have different displays, which are shown in the fi gures below. RQ1187CC, RQ1187 RQ1167 Charging Charging takes approx. 1 hour.
After approx. 30 minutes, the display automatically switches off again. Battery low RQ1187CC, RQ1187 When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the bottom charging light fl ashes orange. When you switch off the shaver, the bottom charging light continues to fl...
Page 38
Charging Charging takes approx. 1 hour. RQ1187CC, RQ1187: A fully charged shaver has a shaving time of up to 50 minutes. RQ1167: A fully charged shaver has a shaving time of up to 45 minutes.
(2). The display shows that the shaver is charging (see section ‘Charging’ in chapter ‘The display’). Charging in the Jet Clean system (RQ1187CC only) Put the small plug in the Jet Clean System. Put the adapter in the wall socket.
Page 40
Move the shaving heads over your skin in circular movements. Do not make straight movements. Press the on/off button once to switch off the shaver. RQ1187CC, RQ1187: The display lights up for a few seconds and then shows the remaining battery capacity. Wet shaving You can also use this shaver on a wet face with shaving foam or shaving gel.
Page 41
(1). Then press down the shaving unit (2) to attach it to the shaver (‘click’). Using the Beard styler attachment (RQ1187CC only) Note: Only use the Beard Styler attachment to trim facial hair (beard, moustache and sideburns). Do not use it to trim body parts below the neckline.
Page 42
English Pull the shaving unit straight off the shaver. Note: Do not twist the shaving unit while you pull it off the shaver. Insert the lug of the Beard Styler attachment into the slot in the top of the shaver (1). Then press down the Beard Styler attachment (2) to attach it to the shaver (‘click’).
Page 43
English You can now start styling your beard. Using the Beard styler attachment without comb You can use the Beard Styler attachment without the comb to trim and contour your beard, moustache or sideburns. Pull the comb off the Beard Styler attachment. Note: Grab the comb in the centre to pull it off the Beard Styler attachment.
Page 44
Clean System (RQ1187CC only). The best and most hygienic way to clean the shaver is in the Jet Clean System (RQ1187CC only). You can also rinse the shaver under the tap or clean it with the brush supplied. Clean the shaver after every shave for optimal shaving performance.
Page 45
Reattach the shaving head holder to the bottom part of the shaving unit (‘click’). Cleaning the shaving unit in the Jet Clean system (RQ1187CC only) The Jet Clean System has an automatic cleaning program. When you press the on/off button, the Jet Clean System starts cleaning in this automatic cleaning program.
Page 46
English Fill the cleaning chamber with HQ200 cleaning fl uid to a level between the two lines. Place the Jet Clean System back onto the cleaning chamber. Make sure the release buttons click back into place. Using the Jet Clean system Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System.
Page 47
English , The cleaning light starts to fl ash and the shaver is automatically lowered into the cleaning fl uid. The cleaning light fl ashes throughout the cleaning program, which takes a few minutes. During the fi rst phase of the cleaning program, the shaver automatically switches on and off several times and moves up and down.
Page 48
English Rinse the cleaning chamber under the tap. The cleaning chamber is not dishwasher-proof. Fill the cleaning chamber with HQ200 cleaning fl uid to a level between the two lines. Place the Jet Clean System back onto the cleaning chamber. Make sure the release buttons click back into place.
Page 49
English Lift the retaining frame out of the shaving head holder. Remove the cutter from the shaving guard. Note: Do not clean more than one cutter and shaving guard at a time, since they are all matching sets. If you accidentally put a cutter in the wrong shaving guard, it may take several weeks before optimal shaving performance is restored.
Page 50
Tip: For optimal trimmer performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months. Cleaning the Beard styler attachment (RQ1187CC only) Clean the Beard Styler attachment every time you have used it. Pull the comb off the Beard Styler attachment.
Page 51
Slide the protection cap onto the shaving unit to prevent damage to the shaving heads. RQ1187CC, RQ1187 only: Store the shaver in the pouch supplied. Replacement For maximum shaving performance, we advise you to replace the shaving head holder every two years.
Page 52
To purchase accessories for this appliance, please visit our online shop at www.shop.philips.com/service. If the online shop is not available in your country, go to your Philips dealer or a Philips service centre. If you have any diffi culties obtaining accessories for your appliance, please contact the Philips Consumer Care Centre in your country.
English Environment Do not throw away the shaver and the Jet Clean System (RQ1187CC only) with the normal household waste at the end of their life, but hand them in at an offi cial collection point for recycling. By doing this, you help to preserve the environment.
Page 54
You have used another cleaning fl uid Only use HQ200 Philips Cleaning than the original Philips cleaning fl uid. Fluid. RQ1187CC only: The Jet Clean System is not connected The Jet Clean to the mains.
Page 55
English Problem Possible cause Solution The shaver is not You have not placed the shaver in the Make sure you press the shaver until it fully charged after charger/Jet Clean System properly. locks into place. I charge it in the charger/Jet Clean System .