Setting Up; Initial Settings; Pws-4400 Settings - Sony PWS-100PR1 Operation Manual

Setting Up

Initial Settings

Before using the unit, configure the Windows settings
within the unit. The description below describes the
standard settings in Windows 8.
Note
To reboot the unit, first shut down the unit and then turn the On/Standby
button on the front panel on again, without rebooting Windows.
1
Connect a keyboard and mouse to the USB connectors
on the front panel, and connect a monitor to the
DisplayPort connector or HDMI connector on the rear
panel.
2
Turn the On/Standby button on.
3
When the Windows login screen appears, enter "prc"
as the user name, leave the password field blank, and
log in.
Configuring the network
The network settings are configured when installing the
unit.
If the network environment changes, configure the
network settings for the new environment.
1
Connect a LAN cable to the LAN connector on the rear
panel of the unit, and connect the other end to the
network.
2
Click [View network status and tasks] under [Network
and Internet] in the control panel.
3
Click the device connected by LAN cable in
[Connections].
4
Click the [Properties] button.
5
Select [Internet Protocol Version 4 (TCP/IPv4)], then
click the [Properties] button.
6
Change the IP address and other settings.
7
Click the [Advanced] button to configure DNS,
WINS, and other settings.
8
When finished, click the [OK] button.
Setting the date and time
1
Select [Set the time and date] under [Date and Time]
in the [Clock, Language, and Region] control panel.
2
Click [Change time zone] on the [Date and Time] tab,
and select the time zone.
3
Click [Change date and time] on the [Date and Time]
tab, and set the date and time.
4
Click the [Change settings] button on the [Internet
Time] tab.
5
Specify an NTP server, then click the [Update Now]
button.
6
Place a check mark in [Synchronize with an Internet
time server] to periodically correct the clock using the
NTP server.
Setting user passwords
The default user "prc" is configured for Windows within
the unit. Set the password for the user to provide security.
1
Click [User Accounts and Family Safety] in the
control panel.
2
Click [User Accounts] > [Change account type].
3
Select the "prc" user.
4
Click [Change the password].
5
Enter a new password and a password hint, then click
the [Change Password] button.
Signing out
When finished, sign out from Windows.
1
Move the mouse cursor to the top right corner of the
screen to display the Charms bar, then click [Start].
2
Click the account name on the top right of the screen,
then click [Sign out].

PWS-4400 Settings

Configure the input/output port settings on the PWS-4400.
For details about configuration, refer to the PWA-PRC1
Installation Guide, and the PWS-4400 Operation Manual.
15
Setting Up