Loose Parts - Toro Power Max 1028LXE Operator's Manual

1. Left turn control
2. Traction drive—squeeze
the lever to engage; release
the lever to disengage.
Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.
3.
4.
5.
6.
7.
8.
9.
3. Auger/impeller
drive—squeeze the lever to
engage; release the lever
to disengage.
4. Right turn control
Description
Handle bolts
Curved washers
Locknuts
No parts required
No parts required
Carriage bolts
Locknuts
Cable tie
No parts required
No parts required
No parts required
No parts required
112-6622
5. Read the Operator's
Manual.
6. Do not place your hand
in the chute; stop the
engine before leaving the
operator's position, use the
tool to clear the chute.
Qty.
4
4
4
–
–
2
2
1
–
–
–
–
6
7. Thrown objects, keep
bystanders a safe distance
from the snowthrower.
8. Keep away from moving
parts, remove the
ignition key and read
the instructions before
servicing or performing
maintenance.
Use
Install the upper handle.
Install the wheel clutch cable ends
Install the traction control linkage.
Install the chute control rod.
Connect the wire to the headlight.
Fill the engine with oil.
Check the tire pressure.
Check the skids and scraper.
Check the operation of the traction drive.