Table of Contents
Advertisement
Recognize this symbol as an indication
of important safety information.
Inspection
•
Carefully check the shipment against the bill of lading.
•
Make sure correct chassis has been received (
tions).
•
Verify your equipment by using "model nomenclature" on
page 7.
Verify unit:
•
Unit size and type correct per submittal sheet and job requirements?
•
Voltage correct?
Verify options (if any):
•
Capacity, electric heat, if used?
•
Hydronic coil included, if required? Piping located as required?
•
All other factory installed options installed, if any?
•
All field installed options included, if any?
Shipping damage MUST be reported to
the carrier IMMEDIATELY.
•
Examine the exterior.
•
Remove cover and examine
compressor and piping for signs
of damage.
•
Inspect each component for damage.
•
Concealed damage must be reported to the carrier
within 15 days of the receipt of the shipment.
•
The carrier must make proper notation on the delivery
receipt of all damage identified and complete a carrier
inspection report.
•
The purchaser must notify ECR International's Cus-
tomer Service department of all damage and is respon-
sible for filing any necessary claims with the carrier.
Customer Service : (800) 228-9364
P/N 240008071, Rev. B [112309]
Water Source Console Units
• Installation, Operation, and Maintenance Manual •
Read This First
(continued)
General precautions
Electrical Supply
Carefully read the rating plate located on the front panel.
The RetroAire replacement Water Source Console Units
must:
as well as any op-
Do not modify the RetroAire replacement
Water Source Console Units
Do not attempt to modify or change this unit in any way. Tam-
pering with RetroAire replacement Water Source Console Units
is dangerous and may result in serious injury or death. Tamper-
ing voids all warranties.
Power Cord-Optional
The power cord supplied with the RetroAire replacement Wa-
ter Source Console Units should be checked before every use.
Follow the instructions in the order listed on the device. Do not
use the product if the cord fails the test. A damaged power supply
cord must be replaced with a new cord from the manufacturer and
not repaired. The use of extension cords is prohibited.
Failure to follow these instructions can result in a fire, explo-
sion or electrical shock causing property damage, personal
injury or death.
Save these instructions — this manual is intended as an
aid to qualified service personnel for proper installation,
operation, and maintenance of RetroAire replacement Water
Source Console Units.
Read all instructions thoroughly and carefully before at-
tempting installation or operation. Install or locate this unit
only in accordance with these instructions. Use this unit only
for its intended use as described in this manual.
Turn off the electrical supply before servicing the unit.
Water Source Console Units chassis are heavy. To avoid injury,
use assistance when lifting.
Do not use the unit if it has damaged wiring, is not working
properly, or has been damaged or dropped.
Failure to follow these instructions may result in improper installa-
tion, operation, service, or maintenance, possibly resulting in fire,
electrical shock, property damage, personal injury, or death.
3
DANGER
Be properly connected
•
to electrical supply with the
proper voltage as stated on the rating plate.
•
Be properly grounded
.
Use the properly-sized over-current protection
•
device as stated on the rating plate. (time-delay fuse/
HACR Breaker)
WARNING — Safety instructions
Made in USA
Advertisement
Table of Contents
Troubleshooting
