Figure 3-4. System Information - NETGEAR GSM7324 Installation Manual

5. The login name is "admin". And there is no password assigned. We strongly recommend you enable
password for admin access to secure access to the switch management function. After successful login,
the screen should show (GSM7324)> prompt. Enter "show sysinfo", and it will display the
management CPU's IP address. The switch is shipped with using DHCP as default to receive its IP
address, to manually set a static IP address, first you must first disable DHCP as followed:
(GSM7324) >config network protocol none
Changing protocol mode will reset ip configuration.
Are you sure you want to continue? (y/n)y
After system prompt return, enter the following command
(GSM7324) >config network parms 192.168.1.100 255.255.255.0 192.168.1.1
The example above uses "192.168.1.100" as IP address, and "192.168.1.1" as gateway IP address. You
should provide your own IP address in the above command.
If you want to use your web browser, or telnet session to manage your switch, note the IP address on the

Figure 3-4. System Information.

Page 17 of 24