Technical Support - NETGEAR NAS 1100 Installation Manual

Initialize hard disks (if installed separately)
Duration Act
2 minutes
10 minutes
up to 2 hours
up to 10 hours
a
Error
a
Error
a
Error
a. Installation will abort if an error is detected. Legend :
ReadyNAS connected
directly to your
network.
Description
Initial boot up
Perform RAID configuration on RAIDar (optional)
Volume Creation
ReadyNAS is not accessible during this time
RAID synchronization. ReadyNAS is accessible during this time.
Normal status. ReadyNAS is fully redundant.
No disks detected if all disk LEDs flash at once, and if disk 2 flashes
repeatedly
Bad disk detected if one disk LED flashes once per second.
The disk corresponding to this LED is bad.
Root image needs repair if all 4 disk LEDs flash, and then disk 1 and
disk 2 LEDs flash repetitively.
LED off; LED on; LED slow blinking; LED fast blinking;
October 2007
ReadyNAS connected directly to
your PC (no cross-over cable
needed).
RAIDar Status
Click Setup
Installing
Creating/Booting
Firmware Version
Firmware Version
No disks detected
Firmware Version
Corrupt root
Repetitive pattern
If you purchased a diskless ReadyNAS, after you install the hard disks and perform the
optional RAID Configuration (see the ReadyNAS User Guide for complete instructions),
you must wait until the volume creation has completed before accessing the FrontView™
Setup Wizard (see theReadyNAS Setup Manual). It will take up to 2 hours, depending on
disk capacity.
An additional 2 to 10 hours are required before the RAID synchronization has completed
and the system is fully redundant. During the background RAID synchronization, access
to the NAS will be slower than normal. The RAIDar Status column, shown in the
preceding table, will indicate progress.
Caution: While synchronization is underway, do not turn off the ReadyNAS 1100.
Set up ReadyNAS 1100
Start RAIDar (see the ReadyNAS Setup Manual for complete instructions), and then power
on the ReadyNAS. The ReadyNAS system will appear in the RAIDar scan list. Click
Setup to start the FrontView Setup Wizard. The default user name is admin and the
password is netgear1.

Technical Support

Thank you for selecting NETGEAR products.
At the conclusion of FrontView Setup Wizard configuration, complete your product
registration or, if you choose to register later, you can register your product at
http://www.netgear.com/register.
Registration on the website or over the phone is required before you can use our telephone
support service. The phone numbers for worldwide regional customer support centers are
on the Warranty and Support Information card that came with your product.
Go to http://www.netgear.com/support for product updates and Web support.
This symbol was placed in accordance with the European Union Directive
2002/96 on the Waste Electrical and Electronic Equipment (the WEEE
Directive). If disposed of within the European Union, this product should be
treated and recycled in accordance with the laws of your jurisdiction
implementing the WEEE Directive.
© 2007 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered
trademarks of NETGEAR, Inc. in the United States and/or other countries. Other brand and product
names are trademarks or registered trademarks of their respective holders. Information is subject to
change without notice.