Philips Norelco S7370 Instructions Manual page 15

ENGLISH
28
8 Press the ON/OFF button (
SmartClean System to start the cleaning
cycle.
C
9 The ON/OFF button (
symbol (
◗ The cleaning cycle takes approximately 10
minutes.
◗ Do not press the ON/OFF button while the
cleaning cycle is running. If this does occur, the
cleaning cycle will stop and the cleaning symbol
stops blinking. The cleaning cycle can
be re-started by pressing the ON/OFF button
once.
◗ If the power plug is disconnected before the
cleaning cycle is complete, reconnect the plug
into the outlet and the cleaning cycle can be
re-started by pressing the ON/OFF button
once.
C
NOTE: When the cleaning cartridge filter is full,
the replacement symbol blinks orange. (See
'Replacing the SmartClean System Cartridge').
C
10 When the cleaning cycle is complete and
the shaver is hygienically clean, the ready
symbol lights up continuously.
The battery symbol on the shaver will light up to
indicate the shaver is fully charged.
) on the
) and cleaning
) will light up continuously.
C
11 Press the top cap down (1), pull the
1
shaver forward (2) and lift shaver from
3
SmartClean holder (3).
2
◗ The SmartClean System automatically turns
off 30 minutes after the cleaning cycle is
complete.
12 Carefully shake off excess liquid and let the
shaving unit air dry completely.
You can also leave the shaver in the SmartClean
System overnight to dry.
Extra-thorough cleaning method
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1 Turn shaver OFF.
C
2 Pull the top portion of the shaving unit
straight off the shaver.
C
3 Turn the retaining ring counterclockwise
2
(1) and lift it off the shaving head (2).
1
ENGLISH
29